Spray Rubber Coating K2 Color Flex L343NP — Blue 400 ml

K2 Color Flex L343NP — Blue 400 ml is an aerosol rubber coating formulated to create a flexible, water-resistant protective layer on a variety of surfaces. Supplied in a 400 ml spray can, this blue coating adheres to trims, bumpers, wheel arches, metal and many plastic parts to seal, protect and cosmetically restore surfaces. The product is designed for spray application, cures to a durable yet removable rubber film, and is suitable for short- and medium-term protection against moisture, abrasion and minor surface damage.

Advantages

The aerosol format provides controlled, even application and allows access to recessed areas. The cured rubber layer remains flexible to accommodate movement and vibration without cracking. The coating is water-resistant and resists road dirt and light mechanical wear while being removable when repair or repainting is required. The blue finish offers visual restoration of faded trims and panels and reduces the need for complex surface preparation.

Suitable for

• Automotive exterior trim and bumpers
• Wheel arches and underbody plastic parts
• Metal components requiring temporary protection
• DIY cosmetic restoration and small repairs

Key specifications

• Form: aerosol spray, 400 ml can
• Coating type: rubberized, flexible film
• Color: blue
• Surface properties: water-resistant, removable
• Adhesion: suitable for metal and many plastics
• Durability: resistant to light abrasion and road contaminants

How to use

Ensure the surface is clean, dry and free of grease, rust flakes and loose paint. Shake the can thoroughly before use to ensure uniform dispersion of the coating. Apply several light, even passes from a distance of approximately 20–30 cm, allowing a short flash-off time between coats to build the required film thickness without runs or sagging. After application, allow the coating to cure according to ambient temperature and humidity; full handling strength is achieved once the film has dried and set. For removal, peel or strip the rubber layer where accessible, or use an appropriate solvent or mechanical method following safety guidance.

Usage recommendations

Apply in a well-ventilated area, away from open flames and sources of ignition. Test adhesion on an inconspicuous area if using on unfamiliar plastics. For best results at lower temperatures, warm the can slightly before spraying and allow additional drying time. Use personal protective equipment, such as gloves and eye protection, and follow local waste disposal regulations for empty aerosol cans.