Copper Gas Tee KAN-therm 22 mm - Trójnik gazowy miedziany 22

Copper gas tee KAN-therm 22 mm is a T-shaped fitting designed to join three 22 mm copper pipes in domestic and commercial low-pressure gas distribution systems. Made from copper suitable for gas service, the fitting provides a corrosion-resistant connection point for branching a gas line or replacing a section of piping. It is intended for indoor installations and for use with compatible brazed or press-fit copper joining methods.

Advantages

This copper gas tee offers reliable material compatibility with copper gas lines and good resistance to corrosion under normal indoor conditions. Its T configuration enables straightforward branching of a single gas supply into two directions with minimal flow disruption. The product is produced to meet typical installation requirements for low-pressure gas systems and allows secure joints when installed with appropriate brazing or press-fit techniques by qualified personnel.

Suitable for

• Branching 22 mm copper gas pipelines in residential gas distribution
• Repairing or modifying indoor low-pressure gas networks
• Use in mechanical rooms, utility closets, and boiler connections where 22 mm copper lines are standard

Key specifications

• Material: copper suitable for gas service
• Connection type: T-shaped fitting for three 22 mm pipe connections
• Nominal pipe diameter: 22 mm
• Application: indoor low-pressure gas distribution
• Joining methods: compatible with brazing or approved press-fit techniques

How to use

Prepare the copper pipes by cutting squarely and deburring the ends to ensure full, even contact. Fit the tee onto the 22 mm pipes and complete joints according to the chosen joining method: perform brazing with proper flux and heating or use an approved press-fit system following the tool and manufacturer instructions. Verify alignment and support the piping to avoid stress on joints. All installation work must be performed in accordance with local gas regulations and by qualified installers.

Usage recommendations

Before installation, confirm compatibility with the specific gas type and local code. Use certified joining processes and inspect each joint for integrity and leaks after assembly. Protect the fitting from external mechanical damage and avoid exposure to environments or chemicals that could accelerate corrosion.