KAN-therm stainless steel press tee female threaded 54 x 1/2" x 54 model 191702

KAN-therm stainless steel press tee female threaded 54 x 1/2" x 54 model 191702 is a press-fit Inox tee designed for plumbing and heating installations where a reliable transition from press connections to a female threaded outlet is required. The tee combines two 54 mm press ends for mainline connections with a 1/2" internal thread on the branch, allowing attachment of valves, gauges or secondary lines. Constructed from stainless steel, it is intended for use in potable water and heating systems where corrosion resistance and durable joints are important.

Advantages

The stainless steel construction provides good corrosion resistance and longevity compared with some non-stainless alternatives. Press-fit ends reduce installation time and create consistent, leak-resistant joints when installed with the correct press tool and jaws. The female 1/2" threaded branch offers versatility for connecting conventional fittings, shut-off valves, pressure gauges or small-diameter branch piping without additional adapters. This design supports hygienic potable water systems and standard central-heating circuits.

Suitable for (tasks / use cases)

• Connecting branch valves, pressure gauges or meters to a press-fit mainline in potable water systems
• Creating branches in heating distribution circuits for radiators or secondary loops
• Transition points where a thread connection is required from a stainless press pipeline
• Applications that require corrosion-resistant fittings in contact with water or heating fluids

When it may not be suitable

This Inox press tee is not intended for use with unapproved aggressive fluids or gases outside the manufacturer's stated media and temperature ranges. It may not be suitable where a different thread size, male thread, or special sealing arrangement is required. Also, use is dependent on compatible press-tools and jaws sized for 54 mm stainless press fittings; without the correct equipment, a reliable press joint cannot be achieved.

Key specifications

• Material: stainless steel (Inox)
• End connections: two press-fit ends sized 54 mm
• Branch connection: female (internal) 1/2" thread
• Intended media: potable water and heating fluids
• Typical applications: plumbing distribution and heating systems

How to use

Prepare the pipeline by cutting the stainless steel tube ends square and deburring the inner and outer edges. Insert the tubes fully into the press ends until the stop, and ensure the threaded branch is clean and fitted with the appropriate sealing method for the mating component (e.g., PTFE tape or approved thread sealant). Use a compatible 54 mm press tool and jaws rated for stainless steel press fittings to perform the pressing operation according to tool and fitting manufacturer instructions. After pressing, check visually and, where applicable, perform a pressure test in line with local regulations and system requirements.

What to consider before purchase

• Confirm compatibility of 54 mm press fittings with your existing press tool and jaw set for stainless steel
• Verify that a female 1/2" thread is the required branch connection for your valve or accessory
• Check system media, pressure and temperature ratings to ensure stainless steel press fittings are suitable
• Plan for appropriate sealing method on threaded connections and any required accessories (gaskets, adapters)

Usage recommendations

Install using manufacturer-recommended press tools and follow local codes for potable water and heating systems. After installation, perform pressure and leak tests before commissioning and use compatible stainless steel tubing to maintain corrosion resistance and mechanical integrity.