KAN-therm press equal tee 25 mm K-040025 — copper press fitting for piping

The KAN-therm press equal tee 25 mm K-040025 is a copper press fitting designed to create a branch in a 25 mm piping run. As an equal tee, it provides a continuous straight connection with a perpendicular branch of the same diameter, suitable for use in heating systems, potable water distribution and other pressurized installations where copper press fittings are specified. The fitting is intended for secure, leak-resistant joints when installed with compatible press tools and rings.

Advantages

This copper press equal tee offers corrosion resistance and long-term dimensional stability characteristic of copper fittings. The press connection method provides consistent joint quality and reduces installation time compared with soldered connections. The equal-diameter configuration simplifies line routing and system design where a uniform pipe size is required for the main run and branch.

Suitable for

• Domestic and commercial heating systems
• Potable water distribution and drinking water installations
• Hot and cold water supply networks in buildings
• Pressurized copper piping systems requiring branch connections

Key specifications

• Material: copper
• Connection type: press-fit for use with compatible press tools and seals
• Configuration: equal tee (main run and branch same diameter)
• Nominal diameter: 25 mm
• Application: heating, potable water and general pressurized piping

How to use

Select the correct 25 mm copper pipe and ensure pipe ends are clean, deburred and free of damage. Insert the pipe ends fully into the tee sockets until the stop is reached. Verify the alignment and orientation of the branch before operating the press tool. Use a press tool and jaw or pressing ring compatible with 25 mm copper press fittings to make the permanent mechanical joint. After pressing, check the joint visually and, where required, perform a pressure test of the system in accordance with local codes and project specifications.

Usage recommendations

Use only press tools, jaws and seals rated for copper press fittings and matched to 25 mm diameter. Follow manufacturer guidelines for pressing sequence and testing: ensure system flushing and pressure testing are completed prior to commissioning. Avoid exposing uninsulated copper fittings to dissimilar metals without proper isolation to reduce risk of galvanic corrosion.