KAN-therm Press Elbow 90° 16 mm K-041808 for Press Fittings and Piping

KAN-therm Press Elbow 90° 16 mm K-041808 for Press Fittings and Piping is a compact 90-degree press elbow designed for connecting 16 mm metal and multilayer pipes with press tools. The fitting is intended for use in heating, potable water and refrigeration systems where a reliable, low-profile directional change is required. Manufactured to fit press-style installation methods, this elbow offers a consistent sealed joint that reduces installation time compared with traditional soldering or threaded connections.

Advantages

The press elbow provides a leak-resistant connection when installed with compatible press tools and jaws, delivering consistent mechanical strength and a tight seal. Its 16 mm diameter and 90° angle allow for compact routing in constrained spaces, while the press connection method reduces the need for flame, flux or tape, improving safety and cleanliness on site. The fitting's design supports reproducible joints that are suitable for professional plumbing and HVAC applications.

Suitable for

• Domestic and commercial heating installations
• Potable water supply lines
• Refrigeration and cooling circuits
• Renovation and repair of existing press-fit piping
• Tight or concealed pipe runs where compact directional changes are needed

Key specifications

• Connection type: press fitting for use with compatible press tools and jaws
• Material compatibility: metal and multilayer piping with 16 mm outer diameter
• Angle: 90° elbow for directional change
• Nominal size: 16 mm
• Typical applications: heating, potable water and refrigeration systems

How to use

Prepare the pipe ends by cutting squarely and deburring to ensure full insertion into the fitting. Mark insertion depth if required by the press system, slide the pressed sleeve or fitting onto the pipe, and position the press tool and jaw concentrically around the press zone. Activate the press tool according to the manufacturer's instructions until the press cycle completes and an audible or visual confirmation is given. After pressing, verify the joint visually and, where applicable, perform pressure testing to confirm system integrity before commissioning.

Usage recommendations

Use only press tools and jaws that are compatible with KAN-therm press fittings and rated for 16 mm connections. Follow local codes and manufacturer guidance for pressure testing, support spacing and thermal expansion allowances. For potable water and heating systems, flush the system after installation and inspect joints for proper seating and absence of leaks prior to insulation or concealment.