This is due to long delivery times and limited product warranties.
Save time and money with our discounts!
In cart {{totalProductsCount}} item(s)
Your cart is empty
Memory Module Kingston DDR4 16GB 3200MHz
ValueRAM KVR32S22S8/16 is a 16GB (2G x 64-bit) DDR4-3200 SO-DIMM memory module for laptops. It is configured as 1Rx8, non‑ECC, and uses eight 2G x 8-bit FBGA components. The SPD is programmed to JEDEC standard timings of 22-22-22 at 1.2V and the module fits 260-pin SO-DIMM sockets.
The Kingston DDR4 16GB 3200MHz module provides higher memory capacity and a 3200 MHz clock rate for improved multitasking and application responsiveness compared with lower-frequency modules. Standard JEDEC timings and 1.2V operation ensure compatibility with a wide range of laptop platforms that accept 260‑pin SO‑DIMMs. Non‑ECC design is appropriate for consumer and mobile systems.
Power off the laptop and remove the battery if applicable. Open the laptop memory compartment according to the manufacturer’s instructions, locate an empty 260‑pin SO‑DIMM slot or remove the existing module, align the notch on the module with the slot, insert at an angle and press down until it clicks into place. Reassemble the laptop, reconnect power and start the system; the module should be detected automatically and run at the programmed JEDEC DDR4‑3200 timing if supported by the platform.
Verify motherboard or laptop compatibility for DDR4‑3200 SO‑DIMMs and check maximum supported memory capacity before installation. For best results, install modules in matching pairs and consult the laptop manual for slot population rules.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}