Klimas plastic wall plug KS-10/6x100, anchor dowel for masonry and concrete, size 10 mm, length 100 mm

Klimas KS-10/6x100 is a plastic expansion wall plug designed for anchoring in masonry and concrete. With a nominal diameter of 10 mm and a length of 100 mm, this anchor dowel supports both through and blind fastening methods. The plug expands reliably when a compatible screw is driven in, creating a secure hold for fixtures, cable trays, conduits and lightweight structural elements in solid substrates.

Advantages

The KS-10/6x100 plug is made from durable plastic material that resists cracking under normal installation stresses and provides consistent expansion in drilled holes. Its 10 mm diameter and 100 mm length make it suitable for applications requiring deeper embedment and greater pull-out resistance compared with shorter anchors. The design supports easy installation with standard drills and screws matched to the plug diameter, enabling repeatable, stable anchor performance in masonry and concrete.

Suitable for

• Fixing cable trays and conduit supports to concrete or brick
• Mounting lightweight structural elements and brackets
• Through and blind fastening of fixtures in masonry
• General-purpose anchoring where a 10 mm diameter plug is required

Key specifications

• Material: plastic expansion plug
• Nominal diameter: 10 mm
• Length: 100 mm
• Suitable substrates: masonry, concrete
• Intended fastening: through and blind (sleeve-type expansion)

How to use

Drill a hole in the substrate using an appropriate drill bit matching the plug diameter. Clean the drilled hole from dust and debris to ensure proper expansion. Insert the Klimas KS-10/6x100 plug flush with the surface, then drive a compatible screw into the plug until the sleeve expands and secures the fixture. For through-fixing, pass the screw through the fixture and into the plug; for blind fixing, position the fixture against the substrate before inserting and tightening the screw. Follow recommended torque values for the screw type to avoid over-tightening.

Usage recommendations

Use screws and drill bits sized to the plug diameter to ensure correct fit and expansion. Verify substrate condition—avoid use in heavily cracked or hollow masonry without appropriate reinforcement or alternative anchors. For load-bearing or safety-critical applications, consult applicable standards and use anchors with verified load ratings.