Pipe clamp Kopos OMEGA 5232 ZNM for Ø30–40 mm pipes, steel

Kopos OMEGA 5232 ZNM is a steel pipe clamp engineered to secure round pipes with diameters from 30 to 40 mm. Designed for fixed mechanical support, this clamp is suitable for wall or ceiling mounting in installations where a durable, rigid attachment point is required. The product is intended for use with plumbing, electrical conduit and HVAC piping runs where stable pipe positioning and load-bearing support are needed.

Advantages

The steel construction provides high mechanical strength and long-term dimensional stability under load. The clamp's shape and fastening points enable secure attachment to flat surfaces and structural elements, minimising pipe movement and vibration. Corrosion-resistant surface treatment helps maintain performance in typical indoor environments, and the design allows straightforward installation with common fasteners.

Suitable for

• Securing copper, steel or plastic round pipes with outer diameters of 30–40 mm
• Fixed supports for plumbing and water supply lines
• Pipe runs for electrical conduit and cable trunking in building installations
• HVAC small-diameter ducts and condensate drains

Key specifications

• Material: steel
• Nominal pipe diameter range: 30–40 mm
• Mounting type: wall or ceiling fixed mount
• Surface finish: corrosion-resistant coating
• Design: rigid single-clamp for round pipes

How to use

Select the clamp appropriate for the pipe outer diameter within the 30–40 mm range. Position the clamp around the pipe at the required support point and align the mounting holes with the substrate. Use suitable fasteners (screws, bolts or anchors) appropriate for the mounting surface and expected loads to secure the clamp to wall or ceiling. Ensure the clamp is tightened to hold the pipe firmly without deforming the pipe material; check alignment and spacing with adjacent supports according to the installation plan.

Usage recommendations

Install clamps at regular intervals according to local codes and the pipe manufacturer’s guidance; avoid overtightening to prevent pipe deformation and inspect mounted clamps periodically for corrosion or loosening.