Save time and money with our discounts!
In cart {{totalProductsCount}} item(s)
Your cart is empty
Laptop HDD/SSD caddy Lanberg IF-SATA-10
The Lanberg IF-SATA-10 is a black laptop HDD/SSD caddy made of durable plastic with a height of 9.5 mm. It is designed to accept a single 2.5" drive and to replace the optical drive bay or otherwise fit into compatible laptop drive bays, enabling installation of an additional hard disk drive or solid-state drive. The unit provides a simple way to increase available storage and to separate system and data drives without internal reconfiguration of the main drive bay.
The caddy supports Serial ATA standards including SATA, SATA II and SATA III, ensuring compatibility with a wide range of 2.5" HDDs and SSDs and allowing the drive to operate at the interface speeds supported by the installed drive and host. Its 9.5 mm height and slim plastic construction make it lightweight while remaining sturdy enough for repeated drive swaps. The black finish matches many laptop interiors and provides an unobtrusive installation.
Remove the laptop's optical drive or compatible bay filler according to the laptop manufacturer's instructions, then slide the 2.5" HDD or SSD into the Lanberg caddy until it seats firmly against the SATA connector. Secure the drive in the caddy if applicable using the provided screws or retention method. Insert the assembled caddy into the laptop bay until it clicks or locks into place, and then fasten any external bezel screws if present. Power on the laptop and verify that the operating system recognizes the new drive; format or partition the drive as needed for use.
Before installation, back up important data and ensure the laptop is powered off and the battery removed if recommended by the laptop maker. Use the caddy with drives that match the 2.5" form factor and the 9.5 mm clearance; check drive thickness and SATA compatibility to avoid fit or interface limitations. For quieter operation and lower power draw, consider installing an SSD instead of a mechanical HDD.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}