Spring Pad for Trampoline Lean SPRING PAD (Black) for 244–252 cm (8 ft) trampolines

Lean SPRING PAD is a replacement spring cover designed for circular trampolines with a jumping mat diameter of approximately 244–252 cm (8 ft). The pad has a black PVC outer layer and internal foam padding that covers the springs and the frame edge to reduce the risk of contact injuries and to provide a smoother edge around the jumping surface. It is intended for outdoor family and backyard use and is compatible with trampolines built to the stated diameter range.

Advantages

The black PVC cover provides a weather-resistant surface that sheds water and resists fading, while the internal foam delivers impact cushioning over the springs and frame edge. The replacement pad restores a continuous protective surface on the trampoline and helps maintain safe clearance between the jumping area and exposed metal parts. Its shape and dimensions are matched to standard 244–252 cm circular trampolines, allowing direct replacement without modifying the frame.

Suitable for

• Owners of circular trampolines with a net jumping diameter of about 244–252 cm (8 ft) seeking a replacement spring cover
• Family and backyard outdoor use where protection from exposed springs is required
• Situations where a weather-resistant, easy-to-clean pad surface is preferred

When it may not be suitable

This spring pad is sized specifically for circular trampolines in the stated diameter range and may not fit smaller, larger, or non-circular frames. It will not replace damaged springs, the frame, or the jumping mat; it only covers and cushions the springs and frame edge. For trampolines with non-standard spring arrangements or additional safety enclosures, verify compatibility before purchase.

Key specifications

• Intended trampoline diameter: approx. 244–252 cm (8 ft)
• Cover material: PVC outer layer (black)
• Padding: internal foam cushioning over springs and frame edge
• Shape: circular pad designed to match round trampoline geometry
• Suitable installation: replacement spring cover for outdoor trampolines

How to use

Remove the old spring pad by detaching any fastening straps or clips and sliding the pad away from the frame. Position the replacement pad so that its inner edge aligns with the jumping mat and the outer edge covers the frame and springs. Secure the pad according to the trampoline manufacturer’s recommended method—typically by fastening straps, cords, or hook-and-loop attachments under the frame. Ensure the pad sits evenly around the circumference and that springs and frame are fully covered before use. Periodically inspect the pad for wear, UV damage, or displaced fastening elements and re-secure as needed.

What to consider before purchase

• Confirm that your trampoline is circular and that the jumping mat diameter is within 244–252 cm (8 ft)
• Check that you only need a spring cover and not replacement springs, frame parts, or a jumping mat
• Measure the existing pad and spring arrangement to ensure alignment with the replacement pad’s shape
• Consider exposure to sun and weather; PVC and foam will age over time and may require replacement after prolonged outdoor use

Usage recommendations

Install the pad on a clean, stable trampoline frame and make sure all springs are intact and properly tensioned. Regularly clean the PVC cover with mild soap and water, avoid harsh chemicals, and inspect seams and fastenings seasonally to maintain protective performance.