Speaker cable Lexton PS LEXTON 2x2.00 CU OFC — 2-conductor 2.00 mm² oxygen-free copper

Lexton PS LEXTON 2x2.00 CU OFC is a 2-conductor speaker cable with a 2.00 mm² cross-sectional area per conductor, manufactured from oxygen-free copper (OFC) to support low-resistance signal transmission between amplifiers and loudspeakers. The cable features flexible PVC insulation and is intended for short to medium length runs in home, studio, stage or vehicle audio systems. Available in a 100 m length, this speaker cable is designed to reduce signal attenuation and maintain consistent audio quality in typical installation scenarios.

Advantages

The oxygen-free copper conductors provide improved conductivity and reduced signal loss compared with standard copper, helping to preserve audio fidelity over cable runs. Flexible PVC insulation offers ease of routing in installations while providing electrical isolation and resistance to common mechanical stresses. The two-conductor, 2.00 mm² construction balances current-carrying capacity and flexibility suitable for consumer and professional audio setups.

Suitable for

• Stereo home audio systems and home theater speaker connections
• Multi-room audio installations
• Car audio speaker wiring
• Stage sound and PA system speaker runs
• Connections between amplifiers and passive loudspeakers

Key specifications

• Conductor material: oxygen-free copper (OFC)
• Configuration: 2 conductors
• Cross-sectional area per conductor: 2.00 mm²
• Insulation material: flexible PVC
• Recommended application lengths: short to medium runs (typical home, car, stage use)
• Length: 100 m

How to use

Strip an appropriate length of the outer insulation to expose each conductor, taking care not to nick the copper strands. For secure connections, twist or tin the conductor strands if required by the terminal type, then attach to speaker terminals or amplifier outputs following correct polarity markings. Route the cable to avoid sharp bends and sources of strong electromagnetic interference; secure it with clips or ties as needed. Cut the required length from the 100 m spool and terminate with bare wire, banana plugs, spade lugs or other compatible connectors depending on the installation.

Usage recommendations

Use the Lexton 2x2.00 CU OFC cable for runs where a balance of conductivity and flexibility is required. For longer runs or installations with very high power requirements, consider larger cross-sectional area cable to reduce voltage drop. Keep speaker and amplifier cable runs separated from mains power runs where possible to minimize interference.