Wall lamp LTC LXLL177 solar LED COB 10W 1200 lm with motion and dusk sensor, 1800 mAh battery, IP54 (ABS)

LTC LXLL177 is a solar-powered wall lamp featuring a COB LED that provides 10W output and approximately 1200 lumens of light. The unit integrates an 1800 mAh rechargeable battery, a motion sensor and a dusk sensor to enable automatic on/off operation. Housed in an ABS body with IP54 protection, the lamp is designed for outdoor mounting on walls to provide energy-efficient illumination for entrances, terraces, pathways and garden areas without a wired power connection.

Advantages

The wall lamp combines solar charging with motion and dusk sensing to reduce energy consumption and provide light only when needed. Its COB LED delivers a stable luminous output suitable for general outdoor illumination, while the built-in battery stores energy for overnight operation. The ABS housing and IP54 rating offer resistance to dust and water splashes, supporting reliable outdoor use in typical residential environments. Installation is straightforward because the product does not require mains wiring.

Suitable for

• Garden and backyard wall lighting
• Terrace and patio illumination
• Pathways and steps near an entrance
• Porch or garage sidewall lighting where mains power is not available

When it may not be suitable

This lamp relies on solar charging and its performance depends on the amount of sunlight available; in locations with prolonged overcast conditions or heavy shading the battery may not reach full charge and operating time will be reduced. It is not intended for fully waterproof or submerged installations due to its IP54 rating, so it should not be used in areas exposed to direct jets of water or continuous immersion.

Key specifications

• Light source: COB LED, 10 W
• Luminous flux: 1200 lm
• Power supply: integrated solar charging with rechargeable battery, 1800 mAh capacity
• Sensors: motion sensor and dusk (light) sensor for automatic activation
• Protection rating: IP54 (protection against limited dust ingress and water splashes)
• Material: ABS housing
• Mounting: wall-mounted outdoor fixture

How to use

Mount the lamp on a vertical wall in a location that receives direct sunlight for several hours daily to ensure effective solar charging. Ensure the motion sensor has an unobstructed detection zone and the dusk sensor can detect ambient light levels. After mounting, the unit charges during daylight and will switch on automatically at dusk or when motion is detected, depending on the sensor mode. Periodically clean the solar panel surface and lamp housing to maintain charging efficiency and light output.

What to consider before purchase

• Availability of direct sunlight at the intended mounting location for reliable charging
• Required detection range and angle for the motion sensor relative to the installation position
• Desired level of ingress protection—IP54 is not suitable for immersion or high-pressure wash-downs
• Surface material and mounting method to ensure a secure installation on the chosen wall

Usage recommendations

For best results install the lamp facing south (in the Northern Hemisphere) or in the sunniest available orientation, avoid shading from eaves or vegetation, and clean the solar panel periodically. If longer nightly operation is required, choose a location with maximal daily sun exposure or supplement with additional solar fixtures.