MAGNAPLAST 30° external sewer elbow 160 mm model 22110

MAGNAPLAST 30° external sewer elbow 160 mm model 22110 is an external drainage fitting designed to change the direction of 160 mm sewer pipelines by 30 degrees. Intended for outdoor and below-grade gravity drainage systems, this elbow connects sections of pipe to route flows around obstacles or align runs to inlets, inspection chambers, or sewers. The fitting is compatible with standard 160 mm diameter pipelines used in external sewer and stormwater installations.

Advantages

The elbow provides a controlled, low-angle deviation that reduces flow turbulence compared with sharper bends. Its design facilitates straightforward connection to 160 mm pipelines and supports reliable gravity drainage performance. Constructed for external sewer applications, the fitting resists typical outdoor conditions and allows precise alignment when integrating with inspection chambers, gutters, or main sewer lines.

Suitable for

• Outdoor gravity drainage and sewer runs with 160 mm pipes
• Routing around minor alignment obstacles in external sewer systems
• Connecting pipe runs to inspection chambers, manholes, or main sewers where a 30° offset is needed
• Stormwater discharge lines and surface drainage connections

Key specifications

• Angle: 30° deviation
• Nominal pipe diameter compatibility: 160 mm
• Application: external sewer and stormwater drainage
• Function: direction change elbow for gravity flow systems

How to use

Install the elbow in-line with the 160 mm sewer pipes at the location where a 30° change of direction is required. Ensure pipe ends are clean and free of debris before assembly. Depending on the system, engage the fitting using the appropriate joint method for the pipeline (push-fit, rubber-seal socket, or solvent/weld joints if applicable) and verify alignment with adjoining pipe sections and downstream components. Maintain correct slope for gravity drainage to prevent standing water and check seals for watertight connection after installation.

Usage recommendations

When installing external drainage, inspect surrounding ground conditions and allow access for future maintenance. Use compatible sealing rings or approved jointing materials for 160 mm pipe systems and verify that the elbow orientation achieves the required 30° deviation without inducing backflow or excessive bends elsewhere in the run.