Drill Bit Makita D-07353 10 mm Ø, Length 250 mm, masonry/stone

Makita D-07353 is a 10 mm diameter drill bit with a 250 mm overall length, engineered for drilling masonry and natural stone. The bit is intended for use with SDS-plus-compatible rotary hammer drills and provides extended reach for deep-hole drilling tasks such as anchor installation, conduit runs and plumbing or electrical penetrations. Its geometry and material selection are optimized for efficient removal of masonry material while maintaining hole accuracy.

Advantages

The drill bit offers a balance of length and stiffness for controlled drilling into concrete, brick and similar substrates. Its 10 mm cutting diameter produces standardized holes for common anchors and fasteners. The long 250 mm length enables drilling through thicker elements without the need for extensions, reducing interruptions. The SDS-plus style shank ensures secure tool engagement and quick bit changes on compatible rotary hammer drills.

Подходит для

• Создание отверстий для дюбелей и анкеров в бетоне
• Прокладка труб и кабелей через кирпичные и каменные стены
• Сверление насквозь в толстых стенах и перегородках
• Монтаж систем отопления, вентиляции и кондиционирования

Key specifications

• Diameter: 10 mm
• Overall length: 250 mm
• Intended material: masonry and stone (concrete, brick, similar)
• Shank type: SDS-plus compatible
• Typical use: rotary hammer drilling for deep holes

How to use

Fit the drill bit into the rotary hammer drill’s SDS-plus chuck until it locks securely. Select an appropriate hammer drilling mode and a speed suitable for masonry. Position the bit perpendicular to the work surface and apply steady forward pressure; allow the tool’s hammering action to do the work rather than forcing the bit. Periodically withdraw the bit to clear dust from the hole and avoid overheating. When the required depth is reached, stop the tool and remove the bit.

Usage recommendations

Verify compatibility with your rotary hammer drill before use. For best results, use with a drill that supports SDS-plus bits and select drill speeds and hammer settings according to the substrate. Wear appropriate eye, ear and respiratory protection when drilling masonry. Keep the bit clean and inspect for wear or damage before each use; replace if the cutting tip is worn or the shank is damaged.