Inline skate wheels Nils Extreme PU 70x24 mm 82A white matte (4 pcs)

Set of four Nils Extreme PU inline skate wheels, size 70×24 mm with hardness 82A and a white matte finish. These wheels are designed for recreational and fitness skating, offering a compromise between grip and durability for use on both outdoor pavements and indoor rinks. The wheels fit standard inline skate frames that accept 70 mm wheels and are intended as direct replacements or upgrades for similar recreational setups.

Advantages

The PU compound with 82A hardness provides consistent roll performance and wear resistance while maintaining sufficient traction for varied surfaces. The 70 mm diameter balances maneuverability and speed, making the wheels suitable for casual fitness skating and shorter-distance urban use. A matte white finish gives a neutral appearance that integrates with most skate designs and resists visible scuffs compared with glossier surfaces.

Suitable for

• Recreational outdoor skating on asphalt and concrete
• Fitness and exercise sessions at moderate speeds
• Indoor rink practice where medium-hard wheels are preferred
• Replacement wheels for standard 70 mm inline skate frames

Key specifications

• Wheel diameter: 70 mm
• Contact width: 24 mm
• Material: polyurethane (PU)
• Hardness: 82A (medium-hard)
• Finish: white matte
• Quantity: set of 4 wheels

How to use

Remove the existing wheels from the skate frame following the manufacturer’s instructions and install these 70×24 mm wheels with compatible bearings and axles. Ensure bearings are clean and lubricated or replaced if worn to achieve optimal rolling performance. Tighten axle screws to the correct torque so the wheel spins freely without lateral play. Check wheel alignment and clearance inside the frame before use.

Usage recommendations

Use the wheels on surfaces free of large debris and inspect them periodically for flat spots or excessive wear. For best results, rotate wheels regularly between positions to equalize wear and maintain consistent handling. Replace wheels when tread profile or diameter has noticeably reduced to preserve braking and control characteristics.