Toggle switch NINIGI DPDT ON-ON 3A 250VAC — 2-position, leads for soldering

The NINIGI DPDT ON-ON toggle switch is a compact two-position manual switch designed to switch two separate circuits simultaneously. Rated for 3A at 250VAC, this double-pole double-throw unit provides reliable ON-ON operation and is supplied with soldering leads for straightforward panel or wire-harness mounting. Its small footprint and conventional toggle actuator make it suitable for applications that require a simple, mechanical switching method without complex wiring or bulky hardware.

Advantages

This DPDT toggle switch offers stable mechanical action and clear detents between its two positions, ensuring consistent contact for both poles. The included leads simplify installation by allowing direct soldering to wires or PCB pads, which reduces assembly time in small-batch or repair scenarios. The switch’s 3A/250VAC rating balances current capacity with a compact package, making it appropriate for low- to moderate-current control tasks where space is limited.

Suitable for

• Appliance control panels with simple on/off or circuit-reversal functions
• Audio equipment for signal routing or channel switching
• DIY electronics and prototyping projects requiring manual dual-circuit control
• Repair and replacement in consumer devices and small machinery

Key specifications

• Contact arrangement: Double Pole Double Throw (DPDT)
• Switch positions: 2 (ON-ON)
• Rated current and voltage: 3 A at 250 VAC
• Termination: Soldering leads for direct solder connections
• Actuator type: Toggle
• Mounting style: Panel or chassis with through-hole lead soldering

How to use

Mount the switch in an appropriately sized panel hole or secure it to the chassis so the toggle actuator is accessible. Prepare the cable or wiring harness and tin the conductors before soldering. Heat the soldering point and attach the switch leads to the prepared wires or PCB pads, ensuring solid wetting and mechanical strain relief. Verify correct wiring against the intended circuit diagram for DPDT operation, then test the switch under low power before placing it into full-service operation.

Usage recommendations

Use the switch within its rated limits (3A, 250VAC) and avoid exposing it to prolonged moisture, corrosive atmospheres, or excessive vibration. For current near the rated maximum, inspect solder joints periodically and consider adding mechanical support or heat-shrink tubing to relieve strain on connections.