No name AD-UTP-2W/WG-V2 adapter set — 2× RJ45 to 1× RJ45, network cable adapter

No name AD-UTP-2W/WG-V2 adapter set allows two RJ45 network connections to be combined into a single RJ45 line or split from one line into two. The compact adapter is designed for UTP installations and is compatible with CAT5e and CAT6 patch cords. It provides a quick, low-cost way to reconfigure limited-port network outlets for temporary use, testing, or simple cabling adjustments in home and small-office environments.

Advantages

The adapter set offers a compact, passive solution that requires no power or configuration. It supports standard 8P8C (RJ45) connectors and preserves the physical wiring pairs for typical Ethernet use within the limits of UTP/CAT5e–CAT6 cabling. Its simple form factor makes it easy to carry and install without tools, enabling rapid changes to patching or temporary pair-sharing when additional ports are not available.

Suitable for

• Temporarily combining two network drops into one outlet for limited-port switches or wall sockets
• Splitting a single RJ45 line to feed two non-simultaneous devices for testing purposes
• Short-term network adjustments in home or small office patching scenarios
• Use with UTP/CAT5e and CAT6 patch cords for low-speed or diagnostic connections

Key specifications

• Connector types: 2 × RJ45 (female) to 1 × RJ45 (female) topology
• Cable compatibility: UTP, compatible with CAT5e and CAT6 patch cords
• Construction: passive, no electronic components or power required
• Use case limitation: intended for pair-sharing, temporary or testing connections, not for simultaneous full Gigabit links on combined ports
• Form factor: compact, tool-free inline adapter units

How to use

Insert the RJ45 plug from the source cable into the single-side RJ45 port and connect the destination patch cords to the two RJ45 ports on the opposite side as required. Ensure connectors are fully seated to maintain proper contact. The adapter is passive and does not require any setup; switching between combined and separate connections is done by plugging or unplugging the relevant cables. For testing, connect diagnostic equipment or one device at a time to avoid contention on shared wiring pairs.

Usage recommendations

Use the adapter for temporary or diagnostic scenarios and not as a permanent substitute for additional switch ports or full-port extensions. For simultaneous high-speed connections or Gigabit Ethernet performance, use dedicated cabling or active network hardware. Verify cable type and device requirements before deployment to ensure the adapter meets the intended network function.