Adjustable Four-Way Connector 110/50/50/45-88, grey-green, No name (MPN HP/CN15)

Adjustable four-way connector 110/50/50/45-88 in grey-green is a compact multi-branch component designed to join and direct flows between one larger duct and three smaller outlets. The connector accommodates a primary 110 mm inlet and three adjustable outlets with nominal diameters around 50 mm and a variable 45–88 mm branch, allowing adaptation to piping or ductwork of similar sizes. It is intended for use in ventilation, drainage or light fluid routing where a single compact junction is needed to split or combine flows while maintaining a tidy installation footprint.

Advantages

This connector provides a space-efficient solution for creating multi-branch junctions without the need for extensive custom fabrication. Its adjustable outlets allow installers to fit a range of pipe diameters and angles, reducing the number of different fittings required on site. The grey-green finish offers neutral appearance that integrates into visible or semi-exposed installations. The design supports straightforward assembly and alignment of ducts or pipes, helping to maintain consistent flow paths.

Suitable for

• Domestic and light-commercial ventilation systems where one main duct splits to several branches
• Drainage or condensate routing in renovation projects with constrained space
• Temporary or permanent piping arrangements for low-pressure fluid handling

Key specifications

• Primary inlet diameter: 110 mm
• Secondary outlet diameters: two around 50 mm
• Adjustable branch range: 45–88 mm
• Color/finish: grey-green
• Configuration: four-way junction with adjustable outlets
• Typical applications: ventilation, drainage, light fluid routing

How to use

Position the connector so the 110 mm inlet aligns with the main duct or pipe and slide the corresponding pipe end into the socket until it seats. Adjust the three outlets to match the diameters and angles of the connected pipes; some outlets may require insertion sleeves or sealants to achieve tight fits depending on pipe material. Secure connections with appropriate clamps, brackets or adhesive suitable for the piping material and application. Ensure alignment and gradient where required for drainage to prevent pooling.

Usage recommendations

Use compatible sealing methods (rubber sleeves, silicone, or approved adhesives) to ensure leak-free joints, and verify that connected systems remain within the connector's intended low-pressure and temperature ranges. For ventilation use, minimize sharp bends on attached ducts to reduce airflow resistance. Consult local regulations for drainage installations to confirm suitability.