Elbow pipe fitting 40 mm 67° No name HP/K46C

Elbow pipe fitting 40 mm 67° No name HP/K46C is a compact elbow designed to change the direction of fluid or air flow in piping and conduit systems using 40 mm nominal-diameter pipes. The fitting provides a 67° bend angle, offering an intermediate directional change where standard 45° or 90° elbows are not appropriate. It is suitable for plumbing, HVAC ducting, and conduit routing during renovation, installation, or repair work that requires a non-standard turn within a limited space.

Advantages

The 40 mm 67° elbow delivers a precise, compact directional change that minimizes system re-routing compared with multiple standard elbows. Its intermediate bend angle reduces flow disturbance relative to abrupt 90° turns and allows installers to achieve specific alignments without custom fabrication. The fitting is compatible with standard 40 mm connections and is intended for straightforward installation in confined or complex runs.

Suitable for

• Redirecting water or wastewater flow in plumbing runs with limited space
• Adjusting airflow paths in HVAC or ventilation ducts where a 67° offset is required
• Routing electrical conduit or cable protection systems with non-standard turns
• Repairing or modifying existing pipework to match an unusual alignment

Key specifications

• Nominal pipe diameter: 40 mm
• Bend angle: 67°
• Connection type: compatible with standard 40 mm pipe fittings
• Application areas: plumbing, HVAC, conduit routing
• Form factor: compact elbow for directional change

How to use

Measure and mark the pipe run to determine the exact location for the 67° directional change. Prepare pipe ends according to the pipe material and the fitting’s compatible connection method (clean, deburr, or apply adhesive/sealant if required). Insert or join the 40 mm pipes into the fitting following the standard practice for the pipe system in use, ensuring secure seating and alignment. After installation, verify the joint integrity and test flow through the assembled section under normal operating conditions.

Usage recommendations

Use this 67° elbow where a non-standard angle reduces the need for multiple fittings; confirm compatibility with the pipe material and local codes before installation. For pressurized systems, follow appropriate sealing and pressure-testing procedures. In HVAC or ventilation use, ensure the elbow’s internal profile and material suit the intended airflow and temperature conditions.