Elbow pipe fitting 32x32 mm No name MK32 – 90° connector for 32 mm pipes

Elbow pipe fitting No name MK32 is a 90° connector designed for use with 32×32 mm pipe systems. It joins two 32 mm tubes at a right angle to provide a compact, fixed corner connection for routing pipes, creating tubular frames, or redirecting structural lines. The fitting is suitable for applications in plumbing, heating distribution, furniture frames and general DIY construction where a stable right-angle joint is required.

Advantages

The connector delivers a clean 90° joint without the need for complex machining, allowing quick assembly of pipe runs and frames. Its dimensions are matched to 32 mm tubes to ensure a secure fit and consistent alignment. The simple geometry minimizes material overlap while providing mechanical stability at the corner, making it suitable for fixed installations and load-bearing frame elements when used as intended.

Suitable for

• Plumbing and water routing in non-pressurized or appropriately sealed systems
• Heating distribution pipe runs and radiator connections in framed assemblies
• Construction of metal or plastic tubular frames for furniture, shelving, or displays
• DIY projects requiring right-angle pipe connections

Key specifications

• Connector type: 90° elbow for right-angle joints
• Pipe compatibility: designed for 32 mm outer diameter tubes
• Material: manufactured from standard fitting material suitable for structural and routing use (refer to vendor for exact material specification)
• Application: intended for fixed joints in structural, plumbing and heating assemblies
• Installation: designed for direct joining of two tubes at 90° without additional shaping

How to use

Prepare both 32 mm tubes by ensuring ends are cut square and free of burrs. Insert each tube into the fitting until fully seated and aligned at the intended right angle. Depending on the installation method and material, secure the connection using the recommended fastening method specified by the supplier—this may include set screws, adhesives, welding, or mechanical clamps. Verify alignment and fixity before applying any load or pressure to the assembly.

Usage recommendations

Use the elbow fitting with tubes that match the specified 32 mm outer diameter and follow the supplier’s guidance on fastening and material compatibility. For pressurized fluid systems or high-load structural uses, confirm that the fitting material and fastening method are rated for the intended pressure and mechanical loads; when in doubt, consult a qualified installer or engineer.