Dimmer Opal SO-1P MOD.SREBRO 40–400W silver pearl — single‑pole lighting dimmer

The Opal SO-1P MOD.SREBRO 40–400W silver pearl single‑pole lighting dimmer provides manual brightness control for compatible lighting loads within a 40–400 W range. Finished in a neutral silver pearl, the dimmer is intended for installation in standard wall switch locations and is suitable for residential and commercial interiors where a simple, tactile control for light level adjustment is needed. The device operates as a single‑pole unit, controlling the live feed to the connected lamp circuit to raise or lower luminous output smoothly.

Advantages

This Opal single‑pole dimmer offers smooth analog dimming across its rated load range and a compact form factor that fits standard wall mounting. The silver pearl finish provides a discreet, neutral appearance that integrates with a variety of interior styles. The unit is designed for straightforward manual operation and delivers consistent performance within its specified wattage limits.

Подходит для

• Регулировки яркости накаливания и диммируемых ламп в жилых помещениях
• Освещения в общественных или коммерческих зонах с простым управлением
• Замены обычного настенного выключателя на устройство с функцией затемнения

Key specifications

• Operating mode: single‑pole (controls one circuit)
• Load range: 40–400 W
• Compatible loads: incandescent and dimmable lighting types within rated power
• Finish: silver pearl (metallic neutral tone)
• Mounting: standard wall switch location, single‑gang compatible
• Control type: manual rotary or rocker dimming interface (mechanical)

How to use

Install the dimmer in place of a standard single‑pole switch following local electrical regulations and with the power supply turned off. Connect the live and load conductors to the designated terminals and secure the unit in a standard mounting box. After restoring power, adjust brightness by turning or actuating the unit’s control until the desired light level is reached. Do not exceed the specified load range and ensure connected lamps are marked as dimmable where required.

Usage recommendations

To maintain reliable operation, use the dimmer only with compatible dimmable lamps and avoid connecting loads below 40 W or above 400 W. For installations in circuits with mixed lamp technologies or electronic drivers, verify driver compatibility with resistive/phase‑cut dimming. If uncertain, consult a qualified electrician for proper selection and wiring.