Clamp for Pipes PAWBOL H.7332 single 14–25 mm pack 100 pcs

Single pipe clamp PAWBOL H.7332 is designed to secure pipes with diameters from 14 to 25 mm in domestic and light commercial installations. Supplied as a pack of 100 pieces, each clamp provides mechanical support for plumbing, heating and electrical conduits when fastened to walls or structures with conventional screws or anchors. The product is intended for straightforward, repeatable fixing where consistent spacing and secure retention of small-diameter pipes are required.

Advantages

This pack of 100 single clamps offers a consistent, ready-to-use solution for mounting pipes 14–25 mm in diameter. The clamps are simple to install and provide reliable mechanical support when used with appropriate fasteners. Their standardized size and shape help ensure uniform pipe alignment and easy replacement or reconfiguration of runs during maintenance or extension of systems.

Suitable for

• Securing water supply and drainage lines with outer diameters between 14 and 25 mm
• Fixing heating system pipes such as small-diameter radiator or underfloor heating feeders
• Routing and fastening electrical conduits or protective sleeves of similar diameter
• Domestic renovations and light commercial installations requiring multiple identical clamps

When it may not be suitable

This clamp is not intended for pipes with diameters outside the 14–25 mm range; using it on significantly larger or smaller pipes will not provide proper support or retention. It is also not designed for high-load structural support or for applications requiring vibration isolation, thermal insulation, or chemical resistance beyond what ordinary plastic and metal fastening systems provide.

Key specifications

• Pipe diameter range: 14–25 mm
• Pack quantity: 100 pieces
• Type: single (one-pipe) clamp
• Mounting method: fixed to substrate with screws or anchors
• Typical applications: plumbing, heating and electrical conduit fastening

How to use

Position the clamp over the pipe at the required fixing point and mark the mounting hole location on the substrate. Pre-drill and insert an appropriate anchor if fixing to drywall or masonry, or use a suitable screw for timber or metal substrates. Place the clamp so that the pipe sits securely in the cradle and fasten the clamp with the selected screw or anchor. Space clamps at regular intervals along the pipe run according to the pipe manufacturer’s recommendations or local codes to ensure adequate support.

What to consider before purchase

• Verify the actual outer diameter of the pipe falls within the 14–25 mm range
• Choose suitable screws or anchors for the mounting substrate and expected loads
• Confirm whether additional vibration or thermal isolation accessories are needed for the application
• Consider clamp material compatibility with the pipe material and the installation environment

Usage recommendations

For best results, follow pipe spacing guidelines from the pipe manufacturer or local regulations, use corrosion-resistant fasteners where required, and check that clamps are not overtightened to avoid deforming the pipe while ensuring a secure hold.