Lighting starter Philips SND 58 220-240V 50/60HZ

The Philips SND 58 220-240V 50/60HZ lighting starter is designed for use with AC mains supplies in the 220–240 V range at 50 or 60 Hz. It is a compact, single-unit starter built to function reliably across a broad operating temperature range from -20 °C to 85 °C. With a lightweight housing and small footprint, the starter is suited for retrofit or new installations where a reliable ignition component for discharge and fluorescent luminaires is required.

Advantages

The starter offers consistent ignition performance across the specified voltage and frequency range and maintains operation in low and high ambient temperatures. Its compact dimensions and low weight make handling and installation straightforward. The device is supplied as a single unit, allowing replacement or stocking as needed without bulk packaging. The design conforms to common fitting requirements for compatibility with a range of lighting fixtures.

Suitable for

• Starting and ignition circuits in fluorescent lighting fixtures
• Replacement of failed or aged starters in commercial and domestic luminaires
• Maintenance spares for lighting installers and facility managers

Key specifications

• Input voltage: 220–240 V AC
• Frequency: 50/60 Hz
• Operating temperature range: -20 °C to 85 °C
• Weight: 50 g
• Dimensions (approx.): 84.5 mm (width) × 38.5 mm (height)
• Packaging: single unit

How to use

Install the starter in the designated starter socket of the fluorescent or discharge lamp fixture while the power is switched off. Ensure correct seating of the starter contacts and restore mains power to allow the starter to perform ignition cycles. Replace the starter if signs of wear, flickering, or failure to start the lamp are observed. Follow the luminaire manufacturer's guidance for access and any additional safety instructions.

Usage recommendations

Use the starter within the specified voltage, frequency, and temperature ranges to ensure reliable operation. Store spare units in a dry environment and handle the device carefully to avoid mechanical damage to the housing or contacts. For maintenance, disconnect power before removal and disposal according to local regulations.