Memory module PNY KSM32ES8/8HE 8 GB DDR4 3200 MT/s 288-pin DIMM ECC CL22

PNY KSM32ES8/8HE is an 8 GB DDR4 288-pin DIMM designed for server and workstation environments where ECC memory is required. This single-rank module operates at DDR4-3200 (3200 MT/s) with a CAS latency of 22 and standard 1.2 V supply, and incorporates on-board SPD EEPROM and temperature reporting for system compatibility and monitoring. The module follows JEDEC timing for DDR4-3200 and uses gold contact fingers to interface with compatible DIMM slots.

Advantages

The module offers error-correcting code (ECC) support to detect and correct single-bit memory errors, contributing to improved system reliability. Its single-rank 8 GB capacity and DDR4-3200 data rate provide a balance between capacity and bandwidth for server workloads. Integrated SPD and temperature sensor simplify automatic configuration and monitoring in supported systems, while JEDEC-standard timing and a 288-pin DIMM form factor ensure broad motherboard compatibility.

Suitable for

• Server and rack-mounted systems requiring ECC memory
• Workstations used for data processing and professional applications
• Memory upgrades where a compact 8 GB DDR4 DIMM is sufficient
• Systems that require JEDEC-standard DDR4-3200 modules with SPD support

Key specifications

• Memory type: DDR4 SDRAM
• Capacity: 8 GB
• Data rate: 3200 MT/s (DDR4-3200)
• CAS latency: CL22
• Rank and organization: Single-rank, 1Rx8
• Voltage: 1.2 V nominal for VDD and VDDQ
• Package components: based on nine 1G x 8-bit FBGA components
• On-board features: ECC support, SPD EEPROM, temperature sensor
• Internal banks: 16 (4 groups of 4 banks)
• Burst settings: BC4 and BL8 selectable via mode register set
• Topology: Fly-by command/address topology with terminated control bus
• DIMM form factor: 288-pin gold-plated contact fingers; PCB height 31.25 mm
• Compliance: RoHS compliant, halogen-free

How to use

Install the PNY 8 GB DDR4 DIMM into an available 288-pin ECC-capable DIMM slot on a powered-off motherboard, aligning the module notch with the slot key and pressing evenly until the retention clips engage. Ensure the system BIOS or firmware supports DDR4-3200 and ECC operation; the SPD EEPROM provides JEDEC timing which most servers and workstations will read automatically. After installation, power on the system and verify that the BIOS/UEFI and operating system recognize the new memory and report ECC status if supported.

Usage recommendations

Use this module in systems that explicitly support ECC unbuffered DDR4 DIMMs and DDR4-3200 JEDEC timings. Install modules in matched pairs or configurations recommended by the motherboard vendor for optimal stability and performance. Avoid mixing modules with different voltages, speeds, or ECC/non-ECC types in the same system to prevent compatibility issues.