Laminator power plant PP-141 A4, 80–100 µm pouch capacity, 350 mm/min speed

The Power Plant PP-141 A4 laminator accepts pouches 80–100 µm thick and laminates at a speed of 350 mm/min. It is a compact device intended for home, school or small office use and protects photos, business cards, certificates and printed sheets from moisture, dirt and wear. The unit supports both hot and cold lamination and fits documents up to A4 size with a maximum lamination width of 230 mm.

Advantages

Two rollers ensure even adhesion of the pouch film to the document surface, including areas close to the edge. A maximum operating temperature of 125 °C provides consistent lamination quality. The compact dimensions and straightforward operation make the laminator suitable for occasional to light daily use where space is limited.

Suitable for

• Photos and photographs
• Business cards and ID cards
• Certificates and diplomas
• A4, A5 and A6 printed sheets and brochures

Key specifications

• Supported pouch thickness: 80–100 µm
• Lamination speed: 350 mm/min
• Operating temperature: up to 125 °C
• Preheat time: approx. 4 minutes
• Maximum lamination width: 230 mm (A4)
• Lamination modes: hot and cold
• Power: 145 W, 0.63 A
• Voltage: 220 V, 50 Hz
• Dimensions: 340 x 110 x 50 mm
• Warranty: 12 months

How to use

Place the laminator on a flat, stable surface and connect it to a compatible power supply (220 V, 50 Hz). Allow the device to warm up for the indicated preheat time (about 4 minutes) before inserting a sealed pouch containing the document. Feed the pouch straight into the feed slot with the sealed edge first; the rollers will pull and laminate the pouch. For cold lamination, switch to the cold setting and follow the same feeding procedure. After use, disconnect the device and allow it to cool before storing.

Usage recommendations

Use pouches within the supported 80–100 µm range and avoid inserting warped or overfilled pouches to prevent jams. For best results with sensitive prints or photographs, test on a single sheet first and allow the laminated item to cool flat before handling.