Aerial amplifier Prolech Pilot universal antenna amplifier for DVB-T terrestrial TV

The Prolech Pilot universal antenna amplifier for DVB-T terrestrial TV is an RF amplifier designed to improve reception of over-the-air digital broadcasts. It is intended for use with rooftop or indoor TV antennas to increase signal strength and stabilise DVB-T picture and sound in locations with weak or marginal coverage. The device works by amplifying incoming terrestrial signals to reduce pixelation, dropouts and intermittent reception.

Advantages

The amplifier provides a consistent gain to strengthen weak DVB-T signals without altering channel tuning. Its universal compatibility allows use with a wide range of passive rooftop and indoor antennas. The compact design is suitable for mounting near the antenna or inside an equipment cabinet, limiting cable loss by amplifying the signal close to the source. The unit is built for continuous operation and supports typical DVB-T frequency ranges used for terrestrial television.

Suitable for

• Homes and apartments located at the edge of DVB-T coverage areas
• Rooftop antennа installations suffering from weak signal or interference
• Indoor antenna setups where cable length causes attenuation
• Small communal installations where several receivers use a single antenna

Key specifications

• Function: RF amplification for DVB-T terrestrial TV reception
• Compatibility: universal with passive rooftop and indoor TV antennas
• Application: designed to reduce pixelation and dropouts in marginal coverage
• Installation location: near antenna or in an equipment enclosure to minimise cable loss
• Operation: continuous signal amplification for stable picture and sound

How to use

Install the Prolech Pilot amplifier between the antenna and the coaxial feed to the TV or distribution splitter. Mount the unit close to the antenna to reduce pre-amplifier cable loss, then route the amplified signal to the receiver or multiswitch. Power the amplifier according to the manufacturer’s installation method (power supply arrangement provided with the device or via an in-line power inserter) and check signal quality on the TV. Adjust the antenna direction if necessary after powering the amplifier to achieve optimal reception.

Usage recommendations

Place the amplifier as close to the antenna as practical to minimise cable attenuation before amplification. Avoid excessive overall gain that may cause overloading when strong local transmitters are present; if needed, isolate or attenuate overly strong signals or adjust antenna placement. Use quality coaxial cable and connectors to preserve improved signal quality.