Proskit Desoldering Braid 2.5 mm width 1.5 m length 8PK-031C

The Proskit desoldering braid model 8PK-031C is a reliable desoldering wick featuring a 2.5 mm width and a 1.5 m length. Designed for efficient solder removal and electronic component rework during various repair tasks, this copper braid effectively absorbs molten solder to ensure clean circuit boards and precise desoldering operations for both professionals and electronics hobbyists.

Advantages

This desoldering braid provides efficient thermal transfer to quickly draw up molten solder from connection points. Its specialized weave design maximizes absorption capacity, helping to prevent overheating of sensitive components and circuit boards. The clean removal of solder leaves pads and through-holes ready for new components, minimizing the risk of bridging or short circuits during assembly and repair work.

Suitable for

• Desoldering through-hole electronic components on printed circuit boards
• Reworking and repairing consumer electronics and small appliances
• Removing solder bridges and excess solder from IC pins and pads
• General hobbyist soldering and circuit board maintenance tasks

When it may not be suitable

This desoldering braid is not intended for heavy-duty plumbing applications or large-scale metal joining where high thermal mass requires different types of thermal tools. It may also be less effective for extremely large ground planes that dissipate heat too rapidly without the use of a high-power soldering iron.

Key specifications

• Width: 2.5 mm
• Length: 1.5 m
• Material: Copper wick

How to use

Place the desoldering braid directly over the solder joint you wish to remove. Apply the tip of a heated soldering iron onto the top of the braid. As the copper wick heats up, the molten solder will be drawn up into the braid by capillary action. Once the solder is absorbed, remove the soldering iron and the braid simultaneously. Cut off and discard the used, solder-filled section of the braid before your next application.

What to consider before purchase

• Verify that the 2.5 mm width matches the size of the solder joints on your circuit board
• Ensure you have a suitable temperature-controlled soldering iron capable of transferring enough heat through the braid
• Check the required length for your project to determine if additional spools are necessary

Usage recommendations: Store the desoldering braid in a dry environment to prevent oxidation of the copper material, which can reduce its solder-absorbing efficiency over time. Always use appropriate protective equipment and ensure adequate ventilation when working with electronic repair tools and lead-based or lead-free solders.