M.2 SATA (NGFF) to SATA III Adapter QOLTEC 52265 — supports up to 2TB, SATA 6Gb/s

The QOLTEC M.2 SATA (NGFF) to SATA III Adapter 52265 converts M.2 SATA (NGFF) SSD modules into a standard 2.5" SATA III (6 Gb/s) interface, allowing M.2 SATA drives to be used in systems with SATA connectors. The adapter supports M.2 SATA SSD capacities up to 2 TB and provides a simple plug-and-play solution for adding storage, performing system upgrades or cloning drives. Its compact form factor is suitable for integration into desktop PCs, laptops with 2.5" bays or external drive enclosures that accept 2.5" SATA devices.

Advantages

This adapter enables compatibility between M.2 SATA SSDs and SATA III interfaces without requiring additional drivers, offering straightforward installation and immediate recognition by most operating systems. Supporting transfer rates up to SATA III 6 Gb/s, it preserves the native performance of M.2 SATA modules. The device supports drives up to 2 TB, making it suitable for modern high-capacity SSDs. Its compact and low-profile design makes it easy to install in tight spaces typical of laptops and small-form-factor desktops.

Suitable for

• Upgrading a laptop or desktop to an M.2 SATA SSD via a 2.5" SATA slot
• Cloning an existing system drive to an M.2 SATA SSD
• Using M.2 SATA modules as secondary storage in desktop or external enclosures
• Performing backups and data migration between systems

Key specifications

• Interface conversion: M.2 SATA (NGFF) to SATA III 6 Gb/s
• Supported M.2 type: M.2 SATA (B-key/B+M key where SATA signal present)
• Maximum supported capacity: up to 2 TB
• Form factor compatibility: designed for M.2 2280/2260/2242 (check physical fit)
• Power: standard SATA power via host connection
• Data transfer rate: up to 6 Gb/s (SATA III)

How to use

Power down the host device and disconnect power before installation. Insert the M.2 SATA SSD into the adapter's M.2 slot at the correct insertion angle and secure it with the appropriate mounting screw for the module length used. Connect the adapter to the host using a standard SATA data cable and provide power through the host's SATA power connector or enclosure power source. Power on the system; the drive should be detected by the BIOS/UEFI and operating system. If necessary, initialize, partition and format the drive using the operating system's disk management tools before use.

Usage recommendations

Check the M.2 SSD keying and physical length to ensure compatibility, and verify that the system BIOS/UEFI supports SATA-based M.2 modules. Use quality SATA cables and a stable power source to maintain reliable data transfer and avoid interruptions during cloning or large data transfers.