Coaxial cable Rangeful RP-TNC male to RP-TNC female 1 m LMR400 UF UltraFlex

Rangeful RP-TNC male to RP-TNC female 1 m LMR400 UF UltraFlex coaxial cable provides a flexible, low-loss link for RF signal transmission between devices with RP-TNC terminations. The LMR400 UF UltraFlex construction uses a thicker-diameter center conductor and dielectric design to reduce attenuation while maintaining improved bending performance over standard hard-line cables. This 1 meter cable is intended for short connections in antenna systems, wireless routers, modems and test setups where a robust, higher-performance coax is required.

Advantages

This coaxial cable combines the electrical performance of an LMR400-style conductor with an UltraFlex jacket that eases routing in confined spaces. It delivers lower insertion loss than thinner cables at common RF frequencies, improved shielding to limit interference, and mechanically durable connectors that resist detachment during handling. The RP-TNC male to RP-TNC female pairing provides quick mating with compatible RF equipment while preserving gender-specific pin configuration.

Suitable for

• Connecting external antennas to routers, access points and cellular modems
• Short interconnections in RF test benches and measurement setups
• Wireless base stations and point-to-point radio links requiring low-loss feedlines
• Indoor and protected outdoor installations where flexibility and thicker cable performance are needed

Key specifications

• Cable type: LMR400 UF UltraFlex-style coaxial
• Connector set: RP-TNC male to RP-TNC female
• Length: 1 meter
• Characteristic impedance: 50 ohm
• Low-frequency attenuation: reduced compared with smaller-diameter coax
• Construction: solid center conductor with foam dielectric and flexible outer jacket
• Shielding: multi-layer braid and foil for interference suppression
• Operating environment: indoor and protected outdoor use

How to use

Inspect connectors for debris or damage before installation. Hand-tighten the RP-TNC connectors to the mating RP-TNC ports; use a torque wrench if specified by the equipment vendor to avoid over-tightening. Route the 1 m cable to avoid sharp bends and strain points—maintain bend radii recommended for LMR400-style cables to preserve electrical performance. When used outdoors, protect connectors from moisture with appropriate sealing boots or tape and secure the cable to prevent mechanical stress.

Usage recommendations

For best RF performance, keep runs as short as practical and avoid kinking the cable. Use this LMR400 UF UltraFlex cable where a balance of lower loss and improved flexibility is required; pair with compatible RP-TNC-equipped devices and verify connector type before purchase.