Floor Marking Tape rillprint T61804 — PVC, 50 mm x 33 m, orange, strong adhesion

rillprint T61804 is an orange PVC floor marking tape, 50 mm wide and 33 m long, designed for dependable, high-visibility line marking on floors and other flat surfaces. The tape’s strong adhesion and robust PVC construction make it suitable for creating safety lanes, hazard indicators, walkways and organizational lines in warehouses, factories, retail environments and event spaces. The bright orange colour enhances visibility for both staff and visitors, while the material resists abrasion and general wear from foot and light wheeled traffic.

Advantages

This floor marking tape offers strong adhesive performance on clean, dry surfaces and a durable PVC backing that withstands abrasion. Its bright orange colour provides clear visual contrast for demarcation and safety signalling. The 50 mm width is a practical balance between visibility and material consumption, and the 33 m roll length reduces the need for frequent replacements. The product is simple to apply and removes cleanly from many surfaces when replaced correctly.

Suitable for

• Marking aisles, walkways and safety lanes in warehouses and production areas
• Identifying hazard zones and emergency routes in industrial facilities
• Temporary floor marking for events, exhibitions and retail layouts
• Organising storage areas, pallet locations and traffic flow paths

When it may not be suitable

This tape is intended for general floor marking and light to moderate traffic; it is not formulated as a permanent adhesive for extremely heavy industrial loads or continuous heavy-duty vehicle traffic such as forklifts under high weight. Surfaces that are dirty, wet, oil-contaminated or extremely uneven can prevent proper adhesion and shorten service life.

Key specifications

• Material: PVC backing with pressure-sensitive adhesive
• Colour: orange for high visibility
• Width: 50 mm
• Length per roll: 33 m
• Adhesion: strong adhesion suitable for floors and smooth surfaces
• Resistance: abrasion-resistant PVC designed for foot and light wheeled traffic

How to use

Ensure the surface is clean, dry and free of dust, oil or loose debris before application. Measure and mark the desired line, then apply the tape with consistent pressure along the length to avoid air pockets. For best adhesion, press firmly using a roller or hand pressure along the full tape width. If needed, trim edges with a sharp knife for neat alignment. When removing, lift an edge slowly and pull back at a low angle; use a mild adhesive remover if residue remains.

What to consider before purchase

• Surface type and condition—clean, dry and smooth surfaces ensure optimal adhesion
• Expected traffic—suitable for foot traffic and light wheeled loads but not for continuous heavy vehicle traffic
• Colour choice—orange is high-visibility for safety and hazard marking
• Required run length—each roll provides 33 m at 50 mm width

Usage recommendations

Apply at room temperature on prepared surfaces and allow a short dwell time after application for the adhesive to develop full bond. For long-term applications in high-traffic areas consider periodic inspection and replacement of worn sections to maintain visibility and safety.