Brush guard for robot vacuum Roborock 8.02.0242 – grey, replacement accessory for Roborock Qrevo series

Roborock 8.02.0242 is a grey brush guard designed as a replacement accessory for robot vacuums in the Roborock Qrevo family. It covers and protects the main brush assembly to reduce hair and debris entanglement and help maintain consistent brush performance. The part is supplied as a single boxed unit and is intended for use with compatible Qrevo, Qrevo S, Qrevo Pro and Qrevo Plus models.

Advantages

The brush guard provides physical protection for the main brush, limiting direct contact between the brush and larger debris while helping to guide tangled hair away from the rotating elements. Made in a neutral grey finish, it preserves the appearance of the vacuum and is supplied ready to install, which simplifies maintenance routines. Replacing a worn or damaged guard can restore original brush coverage and reduce the frequency of manual cleaning.

Suitable for

• Owners of Roborock Qrevo, Qrevo S, Qrevo Pro and Qrevo Plus robot vacuums needing a replacement main brush cover
• Routine maintenance to prevent brush jamming and extend brush service life
• Situations with frequent hair, pet fur or fibrous debris where protecting the main brush reduces entanglement

When it may not be suitable

This brush guard is intended specifically for compatible Roborock Qrevo-series models and may not fit other Roborock families or third‑party robot vacuums. It replaces only the protective cover and does not include the main brush, motor, bearings or other internal components. If the main brush or drive system is damaged, replacing the guard alone will not restore full function.

Key specifications

• Function: Protective guard / cover for main brush
• Compatible devices: Roborock Qrevo family (Qrevo, Qrevo S, Qrevo Pro, Qrevo Plus)
• Colour: Grey
• Package contents: 1 brush guard (boxed)
• Product type: Replacement accessory for robot vacuum

How to use

Power off the robot vacuum and flip it to access the brush compartment. Remove the existing brush guard by releasing its retaining clips or screws following the vacuum’s user manual. Position the Roborock 8.02.0242 guard over the main brush so retention points align, then secure it in place until it clicks or is fastened. After installation, return the robot to its normal position, power on and perform a short test run to confirm correct fit and brush rotation without obstruction.

What to consider before purchase

• Confirm model compatibility with Roborock Qrevo, Qrevo S, Qrevo Pro or Qrevo Plus
• Replacement includes only the brush guard; check the condition of the main brush and any other wear items
• Colour is grey and intended to match the original look of compatible models

Usage recommendations

Install the guard during routine maintenance or when the original cover shows cracks, deformation or excessive wear. Clean the area around the brush regularly and remove accumulated hair to maximise the effectiveness of the guard and reduce strain on the brush drive.