Four-column electrohydraulic lift Rockforce RF-FC50400 5 t 400 V with geometry plates

The Rockforce four-column electrohydraulic lift RF-FC50400 is a heavy-duty vehicle lift rated for up to 5 tonnes and designed for 400 V electrical supply. Built with four load-bearing columns and an electrohydraulic drive, this lift provides stable, level support for passenger cars and light commercial vehicles. Integrated geometry plates allow accurate wheel alignment and steering angle checks without moving the vehicle from the lifting platform. The layout provides clear access to the vehicle underside for maintenance, inspection, tire and suspension service, and general workshop operations.

Advantages

The four-column design ensures high lateral stability and even load distribution across the platform, reducing vehicle movement during service operations. Electrohydraulic actuation offers controlled lifting and lowering with consistent speed and reliable holding under load. Geometry plates are integrated into the platform to facilitate alignment tasks directly on the lift, saving time and minimizing vehicle repositioning. The robust construction and reinforced platforms support routine workshop usage and frequent lifting cycles.

Suitable for

• Passenger cars and small to medium light commercial vehicles
• Wheel alignment and geometry checks using the integrated geometry plates
• Underbody inspection, maintenance and repair tasks
• Tire and suspension removal, replacement and service

Key specifications

• Maximum lifting capacity: 5 tonnes
• Power supply requirement: 400 V
• Four-column electrohydraulic lifting system for stable elevation
• Integrated geometry plates for wheel alignment procedures
• Reinforced platform design suitable for regular workshop use

How to use

Position the vehicle centrally on the platform and verify that weight distribution is within the platform limits before engaging the electrohydraulic lift controls. Operate the lift using the designated control panel, raising the platform until the required working height is reached and the lift’s mechanical locks engage. Perform wheel alignment procedures by using the built-in geometry plates according to the alignment equipment manufacturer’s instructions. Lower the vehicle only after confirming that personnel and tools are clear of the platform and that the lowering path is unobstructed.

Usage recommendations

Follow regular preventive maintenance schedules for hydraulic fluid, hoses and electrical connections, and inspect safety locks and mechanical components before each use. Use this lift in a workshop environment with appropriate floor loading capacity and trained operators experienced with four-column electrohydraulic lifts.