Module Ropam EXP-I8 — input expander module for security and automation systems

Ropam EXP-I8 is an input expander module designed to add multiple digital inputs to security, alarm and automation controllers. As a peripheral module it provides additional channels for sensors, switches and detectors, enabling expanded monitoring and control in building automation and alarm systems. The module is intended for integration with compatible Ropam controllers and supports straightforward wiring of zone inputs to extend system coverage without replacing the main controller.

Advantages

The EXP-I8 increases the number of available digital inputs in an existing security or automation system, allowing you to connect more detectors and switches to a single controller. It supports compact installation in equipment enclosures and simplifies wiring management by grouping multiple inputs in one peripheral. The design facilitates reliable signal transmission from conventional sensors and offers a cost-effective way to scale monitoring capability in both new and existing installations.

Suitable for

• Expanding sensor and switch inputs in alarm systems
• Adding door, window or tamper contacts to building automation
• Integrating conventional detectors into Ropam controller setups
• Increasing input channels in access control and perimeter monitoring

Key specifications

• Number of digital inputs: 8 channels for sensors and switches
• Interface: peripheral module compatible with Ropam controllers
• Mounting: panel or enclosure installation suitable for control cabinets
• Signal type: dry/contact or digital input compatible with standard detectors
• Power consumption: low-power peripheral operation designed for controller integration
• Operating environment: indoor use in typical building automation and alarm installations

How to use

Install the EXP-I8 inside the control cabinet or enclosure in proximity to the main controller and connect it to the controller communication bus following the controller manufacturer’s wiring scheme. Wire each sensor, switch or detector to an individual input channel, observing polarity and contact type requirements where applicable. After physical installation, configure the main controller to recognise the additional inputs and assign them to zones, events or automation rules within the controller’s software or configuration tool.

Usage recommendations

Use shielded cables for long runs to reduce interference, keep signal wiring separate from mains power cables, and follow the controller documentation for addressing and configuration. Verify compatibility with the target Ropam controller model before installation and perform functional tests for each connected input after wiring and configuration.