Microphone foam windscreen Rycote 12 cm SGM (fits 19/22 mm microphones, single)

Rycote 12 cm SGM foam windscreen is a single-sleeve accessory designed to fit handheld and shotgun microphones with body diameters around 19–22 mm. The foam construction provides basic wind noise reduction and dampens plosive bursts while maintaining transparent audio quality. The 12 cm length covers the microphone capsule area commonly used in ENG, field recording, broadcasting and location sound situations where a low-profile, easy-to-fit windscreen is required.

Advantages

The foam material offers consistent attenuation of low- to mid-frequency wind noise without significantly affecting high-frequency detail, preserving intelligibility and natural timbre. Its stretchable design slips over compatible microphone bodies for a secure fit and quick installation or removal. The slim profile keeps the microphone compact and unobtrusive for handheld use, on boompoles or mounted on camera rigs.

Suitable for

• ENG and run-and-gun journalism
• Field recording and location sound
• Broadcast interviews and reporting
• Handheld or on-camera microphone use where basic wind protection is needed

Key specifications

• Length: 12 cm
• Compatible microphone body diameter: approximately 19–22 mm
• Type: single foam windscreen / sleeve
• Material: acoustic foam designed for minimal coloration
• Fit: stretchable slip-on design for secure coverage of the capsule area

How to use

Slip the foam windscreen over the microphone from the rear or front depending on microphone shape, pulling gently until the foam fully covers the capsule area. Ensure the sleeve sits evenly around the microphone head without gaps that would allow direct wind exposure. Remove by stretching the foam slightly and sliding it off; avoid sharp tools or excessive force that could tear the foam. For best results, check the fit before critical recordings and replace the sleeve if it shows signs of wear or damage.

Usage recommendations

Use this windscreen for light to moderate outdoor conditions and indoor work where plosive mitigation and slight wind attenuation are required. For strong wind or exposed outdoor locations, consider combining this foam sleeve with a larger furry windshield or a dedicated blimp system for improved protection.