SCOT RC-1B Additional Push Button for RC-112 Radio Link, Model RC-1B

The SCOT RC-1B Additional Push Button is an external control accessory designed for the SCOT RC-112 radio link system. It provides a single, dedicated input for remote triggering of paired receivers or automation circuits, enabling manual control points for gates, doors, lighting or other compatible radio-controlled equipment. The RC-1B is compact and intended to extend the convenience and flexibility of existing RC-112 installations without altering the main controller.

Advantages

The RC-1B offers a straightforward mechanical interface that simplifies remote activation of devices connected to an RC-112 receiver. It is easy to mount near entry points or control panels, requires minimal wiring to integrate with existing installations, and preserves original system behavior by acting as an additional input rather than replacing the primary controller. The simple design reduces failure points and supports reliable manual operation in routine or emergency scenarios.

Suitable for

• Adding a manual control point for automatic gates or garage doors
• Manual triggering of lighting circuits controlled via RC-112 receivers
• Remote activation of automation relays in residential or light commercial installations
• Supplementing existing radio link systems where an additional physical push button is needed

When it may not be suitable

The RC-1B is intended as an accessory input for compatible RC-112 receivers and is not a standalone transmitter or full controller. It does not provide wireless signalling by itself; a wired connection to the receiver or control unit is required. It may not be suitable where multi-button control, advanced programming, or integrated security features (such as encryption or rolling codes) are required unless supported by the connected RC-112 system.

Key specifications

• Function: Single external push button input for radio link receiver systems
• Compatibility: Designed to work with RC-112 series radio link receivers and compatible control units
• Installation: Surface or panel mounting with short wiring to receiver/input terminal
• Operation: Momentary mechanical push button for manual triggering
• Physical: Compact form factor suitable for installation near access points

How to use

Mount the RC-1B in a convenient location close to the device or access point where manual control is required. Run the required wires from the push button terminals to the designated input terminals on the RC-112 receiver or compatible control module, following the receiver manufacturer’s wiring diagram and local electrical regulations. Use the button for momentary activation; the connected receiver or automation circuit will perform the configured action on input closure. Verify correct operation after installation and secure wiring and enclosure to prevent ingress or accidental disconnection.

What to consider before purchase

• Confirm compatibility with your existing RC-112 receiver or control unit and check required input wiring type
• Ensure the mounting location allows safe, weather-protected installation if used outdoors or near entrances
• Verify whether additional cabling, connectors, or protective enclosures are needed for your installation

Usage recommendations

For reliable performance, install the push button in a sheltered position and follow the RC-112 receiver manual for wiring and input configuration. Test the input function after wiring and periodically inspect connections for corrosion or loosening in outdoor or high-use environments.