Impeller with Shaft and Cap for Sera Fil 130 and Fil 130+UV - Spare Part SE-30623

Replacement impeller assembly designed for Sera Fil 130 and Fil 130+UV external aquarium filters. The kit contains an impeller, shaft and protective cap engineered to match the original geometry and fitment of the specified Sera filtration units. It restores proper water circulation and pump performance after wear or damage, and is intended for routine maintenance and repairs to maintain reliable operation of the external filter.

Advantages

The impeller assembly is manufactured to provide balanced rotation and reduced vibration, helping to minimize noise and wear on the motor housing. The included shaft and protective cap ensure correct positioning and shielding of the impeller from debris, which supports consistent flow rate and prolongs service life of the moving parts. The component set is a direct-fit spare part that simplifies replacement without requiring modifications to the filter.

Suitable for

• Restoring pump performance in Sera Fil 130 external filters
• Repairing Sera Fil 130+UV units after impeller wear
• Routine maintenance to maintain consistent water circulation
• Replacement of damaged or noisy rotating parts in the filter head

Key specifications

• Complete impeller assembly: impeller, shaft and protective cap
• Precision-molded impeller for balanced rotation
• Durable shaft designed for secure axial alignment
• Protective cap to shield the impeller from solid debris
• Intended for external aquarium filter models with compatible impeller housings

How to use

Turn off and unplug the external filter and disconnect it from the aquarium before attempting replacement. Open the filter housing according to the filter manufacturer's instructions, remove the worn impeller assembly and inspect the impeller well for debris or mineral buildup. Install the new shaft, fit the impeller onto the shaft ensuring correct orientation, and secure the protective cap. Reassemble the filter, reconnect hoses and power, then run the filter and check for smooth rotation, expected flow rate and absence of unusual noise.

Usage recommendations

Perform a visual inspection of the impeller and shaft every 3–6 months, and clean the impeller chamber if you notice reduced flow or increased noise. Use only parts that match the original impeller geometry for reliable operation; replace the assembly if you observe cracks, excessive wear or persistent vibration after cleaning.