Filters you can trust. Pure water every day.
In cart {{totalProductsCount}} item(s)
Your cart is empty
Memory module Silicon Power XPOWER Zenith 16 GB (2×8 GB) DDR4 3600 MHz CL18 1.35 V 288-pin DIMM with heatsink
The Silicon Power XPOWER Zenith 16 GB (2 x 8 GB) DDR4 3600 MHz memory kit delivers high-frequency DDR4 performance in a low-profile design. With a rated speed of 3600 MHz, CAS latency 18 and 1.35 V operating voltage, this 288-pin DIMM kit is intended for high-performance desktops and gaming rigs that require increased bandwidth and reliable stability.
The modules offer automatic overclocking capability and are factory-tested for compatibility with many high-end motherboards, allowing optimized performance for gamers and system modders. A durable aluminum heat spreader with a textured iron-grey finish improves thermal dissipation while keeping a compact height suitable for small-form-factor builds. Multiple PCB layers enhance signal integrity and overall stability.
Power off the system and disconnect from mains before installation. Install the two 288-pin DIMM modules into compatible DDR4 slots on the motherboard, ensuring the module notch aligns with the slot key. Press firmly until the retention clips click into place. After boot, verify memory frequency and timings in the BIOS/UEFI and enable any XMP/DOCP profile if available to reach the rated 3600 MHz. When modifying voltages or timings, proceed incrementally and monitor system stability.
Use the Silicon Power XPOWER Zenith kit in supported motherboards and enable the appropriate XMP/DOCP profile for rated performance. Maintain adequate case airflow and ensure the memory modules do not interfere with large CPU coolers. For overclocking, adjust settings gradually and run stability tests after each change.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}
{{ productComparisonGenerationError }}