Solar cable 4 mm² with PIN plug, 1-pin, 10 m length

Single-core solar cable 4 mm² with a 1-pin PIN plug, 10 m length, designed for low-voltage DC connections in photovoltaic systems. The cable provides a straightforward, single-conductor connection for solar panels, in-line components and short interconnect runs where a single-pin plug is specified. Its 10 meter length allows flexible placement of modules and equipment while maintaining reliable conductive performance for typical rooftop and ground-mounted arrays.

Advantages

The 4 mm² conductor cross-section balances current-carrying capacity and flexibility for short to medium runs in photovoltaic installations. A factory-fitted 1-pin PIN plug enables quick, reproducible connections without on-site crimping. The cable is insulated for low-voltage DC use and is suitable for outdoor routing within standard solar array layouts. Designed for simple installation, it reduces the need for separate connector assemblies on single-pin circuits.

Suitable for

• Connecting individual solar modules to adjacent modules or combiner points where a single-pin connector is required
• Short DC interconnects between panels and microinverters or optimizers with single-pin inputs
• Temporary or permanent wiring runs within arrays on rooftops, carports or small ground-mounted systems
• Linking in-line surge protection, fuses or monitoring devices that accept a single-pin connection

Key specifications

• Conductor: single-core copper equivalent, 4 mm² cross-sectional area
• Connector type: 1-pin PIN plug, factory-assembled on one end
• Length: 10 meters
• Voltage: low-voltage DC suitable for photovoltaic installations
• Usage environment: outdoor-rated for typical solar array exposure when installed per local codes

How to use

Route the cable from the solar module or device to the mating connector or terminal, avoiding sharp edges and high-tension pinch points. Ensure the mating equipment accepts a 1-pin PIN plug and that polarity is observed for DC circuits. Secure the cable with appropriate clamps or cable ties and maintain recommended bending radii to avoid conductor stress. If the cable requires termination at the far end, use compatible connectors or approved terminal blocks following manufacturer instructions and local electrical regulations.

Usage recommendations

Verify system voltage and current requirements to confirm the 4 mm² cross-section is appropriate for the intended run length. Install with proper strain relief, UV-resistant fastening and conduit as needed for additional mechanical protection. Perform polarity checks and continuity tests after installation and follow all applicable photovoltaic installation standards and safety practices.