Electrical trunking accessory STASIŃSKI LK 25x18 angled connector white for cable raceways (1 pc)

STASIŃSKI LK 25x18 angled connector in white is an accessory designed for electrical trunking and cable raceways. Supplied as a single piece, this connector is made to join two sections of trunking at an angle while maintaining a neat and secure junction for indoor cable routing. It is compatible with trunking profiles sized 25 x 18 mm and is intended for use in electrical distribution systems where compact, discreet corner connections are needed.

Advantages

The angled connector provides a reliable mechanical joint that preserves cable alignment and protects conductors from abrasion at the corner. Its white finish offers a discreet appearance that blends with common interior surfaces. The single-piece design enables quick installation without the need for additional fasteners, reducing installation time and simplifying maintenance access.

Suitable for

• Joining two runs of 25 x 18 mm electrical trunking at an angle
• Indoor cable routing in residential and commercial interiors
• Creating clean corner transitions in distribution and control wiring

Key specifications

• Material compatible with standard electrical trunking systems
• Colour: white
• Profile fit: 25 x 18 mm trunking
• Form factor: angled connector for corner joins
• Supply: single piece per pack

How to use

To install, align the connector with the ends of the two trunking runs so that the internal profiles engage evenly. Push the trunking sections into the connector until they seat fully; ensure the joint is flush and that cables inside the trunking are not pinched. If required by the installation standard, secure the trunking to the mounting surface with appropriate clips or screws before or after fitting the connector. Inspect the connection visually to confirm proper seating and cable clearance.

Usage recommendations

Use this angled connector indoors and only with trunking that matches the specified 25 x 18 mm profile. Verify that cables routed through the trunking comply with local electrical codes and that there is sufficient bend radius at corners. For installations with heavier mechanical loads or where sealing is required, complement the connector with suitable mounting hardware or sealing accessories.