Presence Switch Steinel 058463 IP20 180° IR motion sensor switch

Steinel Presence Switch 058463 IP20 180° IR motion sensor switch is an indoor presence detector that automatically controls lighting by sensing human movement within a 180° coverage angle. Designed for mounting in corridors, stairways, offices and utility rooms, the device triggers connected lights when presence is detected and turns them off after a selectable absence period. The IP20 rating specifies suitability for dry indoor environments and the infrared detection focuses on body heat and movement for reliable operation in typical building interiors.

Advantages

The presence switch offers automatic, hands-free control of lighting to reduce energy consumption and eliminate manual switching. Its 180° detection angle and adjustable absence time deliver flexible coverage and tailored behaviour for various indoor layouts. Compact design and straightforward wiring simplify installation into standard lighting circuits. The infrared detection method provides consistent response to human presence while avoiding activation from non-human motion sources in most indoor settings.

Suitable for

• Corridors and hallways
• Stairwells and landings
• Offices and meeting rooms
• Utility rooms, storage areas and technical rooms

Key specifications

• Detection type: passive infrared (PIR) presence detection
• Coverage angle: 180 degrees
• Protection rating: IP20 (for dry indoor use)
• Mounting: wall or ceiling mounting depending on space layout
• Control: automatic on with presence, automatic off after adjustable absence period
• Suitable load: designed to switch typical indoor lighting loads (refer to installation manual for limits)

How to use

Install the presence switch in a dry indoor location where the sensor has an unobstructed view of the area to be monitored. Connect the device to the lighting circuit following electrical safety rules and the manufacturer's installation instructions. Adjust the absence time and any sensitivity settings after power-up to match room use patterns. When installed and configured, the switch will turn lights on when it detects a person in the coverage area and turn them off automatically after the set absence interval.

Usage recommendations

Place the sensor to avoid direct exposure to heating vents or large reflective surfaces, and avoid mounting behind doors that may block the detection field. Test and fine-tune absence time and sensitivity for the specific room to balance convenience and energy savings. Use the device indoors only and observe IP20 limitations regarding moisture and dust.