Presence detector Steinel IR Quattro HD COM1 AP 592400 — 360° detection range

The Steinel IR Quattro HD COM1 AP presence detector delivers full 360° detection coverage for ceiling or wall mounting. Using Steinel's IR Quattro HD sensor technology, this surface-mounted unit senses both motion and presence to control lighting automatically and reduce energy consumption. Designed for corridors, stairwells and rooms requiring complete area coverage, the detector offers reliable detection performance and straightforward installation.

Advantages

The detector provides consistent, all-around sensing capability with a wide detection range designed to eliminate blind spots. Its infrared multi-sensor array improves presence recognition compared to single-element devices, allowing for accurate activation and reliable switching of lighting circuits. The surface-mount format simplifies mounting on ceilings or walls without requiring recessed fixtures, and the device is intended for use in applications where continuous or intermittent presence detection is needed to optimize lighting and energy use.

Suitable for

• Corridors and hallways requiring continuous area monitoring
• Stairwells and landings where full 360° coverage improves safety
• Utility rooms, storage areas and service corridors
• Offices or meeting rooms that benefit from presence-based lighting control

Key specifications

• Detection angle: 360° coverage
• Mounting: surface-mounted for ceiling or wall installation
• Sensing technology: multi-element infrared presence and motion detection
• Typical applications: indoor use in corridors, stairwells and rooms
• Control function: automatic switching of lighting based on detected presence or motion

How to use

Install the presence detector on a clean, flat ceiling or wall surface at the recommended height and position to ensure unobstructed 360° coverage. Connect the detector to the lighting circuit following applicable electrical regulations and the manufacturer's wiring instructions. Adjust sensitivity and timeout settings if available to match the specific room layout and occupancy patterns. After installation, test the detector by walking through the area to confirm reliable activation and proper switching behavior for the connected lighting.

Usage recommendations

Place the detector centrally in the area to be monitored for optimal 360° coverage, avoid mounting near heat sources or air vents that can affect infrared sensing, and configure sensitivity and timeout settings according to typical occupancy to prevent unwanted switching and maximize energy savings.