Synergy21 24V 120W Furniture Power Supply with AMP Terminal Block S21-LED-MOEB250161

The Synergy21 24V 120W Furniture Power Supply with AMP Terminal Block S21-LED-MOEB250161 is a mains-powered low-voltage power module designed for integration into furniture, cabinets and built-in fixtures. It delivers a regulated 24 V DC output with a maximum continuous power of 120 W, and uses an AMP-style terminal block for secure, screw-clamp wire connections. The unit is intended to provide stable power to LED lighting, small control electronics and other low-voltage DC loads in both residential and commercial environments.

Advantages

This furniture power supply provides a constant 24 V DC output with up to 120 W of power, enabling multiple LED strips or small devices to operate from a single, compact unit. The AMP terminal block simplifies installation and ensures firm electrical connections without the need for separate connector housings. Its design for furniture integration supports discreet mounting inside cabinets, plinths or behind panels, while mains input and safety features deliver reliable operation in built environments.

Suitable for

• Low-voltage LED strip lighting in kitchens, display cabinets and shelving
• Powering small DC control modules for dimming, sensors or timers
• Integration into fitted furniture, plinths or custom cabinetry
• Commercial display or retail fixtures requiring concealed power sources

When it may not be suitable

This power supply is not intended for high-voltage or mains-powered loads; it only provides 24 V DC output and must not be used to drive AC appliances. It may not be appropriate where higher total power is required — installations with loads exceeding 120 W will need a higher-capacity supply or multiple units. Also, if a specific connector type other than an AMP-style terminal block is mandatory for your devices, an alternative power supply or adapter will be necessary.

Key specifications

• Output voltage: regulated 24 V DC
• Maximum output power: 120 W
• Output connection: AMP-style terminal block (screw-clamp)
• Intended mounting: furniture/cabinet integration (built-in)
• Primary supply: mains AC input (installed per local electrical regulations)

How to use

Install the power supply inside furniture or behind panels with adequate ventilation and secure mounting according to the enclosure dimensions and local electrical codes. Connect mains input to the supply using properly rated wiring and protective devices such as circuit breakers or fuses. Wire the 24 V DC output from the AMP terminal block to your LED strips or DC devices, observing correct polarity. Verify total load does not exceed 120 W and test the system after installation to confirm stable operation and correct dimming or control behavior if used with controllers.

What to consider before purchase

• Total connected DC load should not exceed 120 W
• Confirm that a 24 V DC output and AMP terminal block are compatible with your LED modules or controllers
• Ensure there is space and ventilation in the furniture for a mains-powered unit and that local wiring can be performed to code
• Check required ingress protection and safety requirements for the intended installation location

Usage recommendations

For best results, plan cable routing and ventilation before installation, group LED runs to balance load on the terminal block, and use a dedicated circuit or appropriate protective device on the mains side. If dimming or control is used, verify compatibility between the controller and 24 V supply and test under full load conditions.