TACWISE 18G Stift nails 20 mm galvanized, pack 5,000 – for pneumatic pin nailers

TACWISE 18G Stift nails 20 mm galvanized, pack 5,000 are thin 18-gauge pin nails designed for use with compatible pneumatic pin nailers. Each pack contains 5,000 zinc-plated pins with a 20 mm length, intended for discreet fastening in finish carpentry tasks such as trim, molding, cabinetry and light joinery. The galvanized finish improves resistance to corrosion for reliable indoor performance and reduced risk of staining on workpieces.

Advantages

These 18G pin nails offer a small head profile and slim shank that minimize visible entry points and reduce splitting in delicate mouldings and narrow trims. The 20 mm length provides sufficient holding power for lightweight assemblies while remaining unobtrusive. Galvanization provides basic corrosion resistance for indoor environments, helping maintain appearance and function over time. Supplied in a bulk pack of 5,000 pins, they are suitable for extended runs of finishing work without frequent reordering.

Suitable for

• Securing trim and mouldings where nail holes should be minimal
• Cabinet door and drawer assembly and repair
• Light carpentry, picture frames and delicate woodwork
• Temporary holding of pieces prior to adhesive curing

When it may not be suitable

These pins are intended for finish and light-duty applications; they do not provide the shear strength or withdrawal resistance required for structural fastening or heavy load-bearing joints. The galvanized coating is suitable for indoor use but may not withstand prolonged exposure to high-humidity or exterior conditions where stainless steel fasteners would be preferable.

Key specifications

• Gauge: 18G (thin pin for finish work)
• Length: 20 mm
• Finish: zinc plated (galvanized) for basic corrosion resistance
• Quantity per pack: 5,000 pieces
• Compatibility: designed for pneumatic pin nailers that accept 18G/20 mm pins

How to use

Load the nails into a compatible pneumatic pin nailer according to the tool manufacturer's instructions and safety guidelines. Set the nailer depth and air pressure suitable for the material being fastened; for delicate moulding, use lower pressure and test on scrap to avoid surface damage. Drive pins flush with or slightly below the surface and, if desired, conceal holes with filler or touch-up paint. Observe standard workshop safety: wear eye protection and ensure the workpiece is stable before firing.

What to consider before purchase

• Verify that your pneumatic pin nailer accepts 18G pins of approximately 20 mm length
• Consider material thickness and required holding strength for the intended application
• Choose galvanized finish for indoor use; select stainless or different coatings for exterior or high-humidity environments

Usage recommendations

For optimal results use these TACWISE 18G 20 mm galvanized pins with a well-adjusted pneumatic pin nailer, test depth and pressure on scrap material before working on visible surfaces, and combine with appropriate adhesives for improved joint strength in cabinetry and moulding tasks.