TACWISE Stiftnails 18G 30 mm galvanized, 5,000 pieces – compatible with pneumatic pin nailers

TACWISE Stiftnails 18G 30 mm galvanized, 5,000 pieces are pin nails designed for pneumatic pin nailers used in finishing and light joinery. Each pin is 18 gauge (approximately 0.7 mm diameter) and 30 mm long, with a galvanized coating that improves corrosion resistance for indoor use. Supplied in a pack of 5,000, these pins are intended to provide consistent, low-profile fastening for trim, mouldings and delicate work where minimal splitting and visible fasteners are required.

Advantages

The galvanized 18G pins offer a balance of strength and thin shank size, allowing secure fastening while reducing the risk of splitting fine timber and moldings. The consistent length and gauge across the 5,000-piece pack support efficient workflow with pneumatic pin nailers, minimising reload frequency. Galvanization enhances resistance to surface corrosion in indoor environments, maintaining reliable holding performance during repeated fastening cycles.

Suitable for

• Fixing decorative trim and skirting boards
• Attaching thin mouldings and beading
• Interior finishing tasks and light joinery work
• Cabinet and furniture face framing where small-headed pins are preferred

When it may not be suitable

These pins are intended for interior use and light-duty fastening. They are not designed for structural connections, heavy-duty load-bearing applications, or exterior use where prolonged exposure to moisture or weathering is expected. For very hard or dense hardwoods the thin 18G shank may not provide optimal withdrawal resistance and could bend or fail under excessive shear loads.

Key specifications

• Gauge: 18G (approx. 0.7 mm shank diameter)
• Length: 30 mm
• Finish: Galvanized coating for improved surface corrosion resistance
• Quantity: 5,000 pins per pack
• Compatibility: Designed for use with pneumatic pin nailers that accept 18G/0.7 mm x 30 mm pins

How to use

Load the pin nailer according to the tool manufacturer’s instructions, ensuring the magazine accepts 18G 30 mm pins. Select appropriate air pressure recommended for the workpiece and fastener length, then test on scrap material to verify drive depth and holding. Position the workpiece firmly and fire controlled shots to avoid surface damage; if necessary, countersink slightly and fill with matching wood filler for an invisible finish. Keep the pins dry and stored in the original pack until use to preserve the galvanized coating.

What to consider before purchase

• Check that your pneumatic pin nailer supports 18G (0.7 mm) pins of 30 mm length
• Confirm that a galvanized finish is acceptable for your indoor project (not intended for long-term exterior exposure)
• Assess substrate hardness—very dense hardwoods may require thicker or different fasteners

Usage recommendations

For best results, adjust air pressure and firing mode on the pin nailer to suit thin moldings; use test pieces to fine-tune depth and holding. When working on visible surfaces, use minimal filler and sand lightly to preserve a clean finish.