TACWISE strip nails 3.1 x 65 mm extra galvanized, D-head, ring shank, paper-collated strip, 2,200 pcs (MPN 1120)

TACWISE strip nails 3.1 x 65 mm extra galvanized are collated D-head fasteners with a ring shank designed for use in compatible strip nail guns. The nails feature an extra galvanized finish to reduce corrosion and are supplied in paper-collated strips with a total of 2,200 pieces for high-volume framing and structural fastening tasks. The D-head profile provides a secure seating under the nail gun drive, while the ring shank increases withdrawal resistance in timber and composite materials.

Advantages

The extra galvanized coating improves resistance to rust and extends service life in exposed construction environments. The ring shank delivers enhanced holding power compared with smooth shank nails, reducing the risk of pull-out in load-bearing timber assemblies. Paper-collated strips allow reliable feeding in compatible strip nail guns and facilitate efficient high-volume installation while minimizing handling time.

Suitable for

• Framing and structural timber connections
• Decking and joist fastening
• General carpentry and outdoor construction where increased corrosion protection is needed
• High-volume fastening with compatible strip nail guns

When it may not be suitable

These nails are intended for use with compatible strip nail guns and are not suitable for hand nailing when paper collation is required for feed mechanisms. The extra galvanized finish offers improved corrosion resistance but is not a substitute for stainless steel in highly corrosive or marine environments.

Key specifications

• Diameter: 3.1 mm
• Length: 65 mm
• Head type: D-head
• Shank type: Ring shank for increased holding power
• Finish: Extra galvanized for improved corrosion resistance
• Collation: Paper-collated strips
• Quantity: 2,200 pieces per pack

How to use

Load the paper-collated strip into a compatible strip nail gun following the tool manufacturer's instructions. Ensure the gun is set to the appropriate pressure and depth setting for 3.1 x 65 mm nails and the material being fastened. Position the gun perpendicular to the work surface and drive nails at recommended spacings for structural applications. Replace strips as needed and dispose of paper collation waste according to local regulations.

What to consider before purchase

• Confirm compatibility of the strip nail gun with 3.1 x 65 mm paper-collated D-head nails
• Assess whether extra galvanized finish meets the corrosion resistance required for your site or if stainless steel is necessary
• Verify that ring shank nails are appropriate for the substrate to avoid splitting thin or delicate timbers
• Plan for storage in a dry environment to maintain finish integrity before use

Usage recommendations

Use the TACWISE 3.1 x 65 mm extra galvanized D-head ring shank nails in appropriate framing and decking applications with a compatible strip nail gun, following tool safety guidelines and local building codes. For maximum holding strength, allow adequate edge and end distances in timber and avoid overdriving the nail head below the surface unless specified by the project requirements.