This is due to long delivery times and limited product warranties.
Save time and money with our discounts!
In cart {{totalProductsCount}} item(s)
Your cart is empty
TV signal amplifier Triax GHV 530
The Triax GHV 530 is a TV signal amplifier designed for distribution systems and antenna installations. It operates across a wide frequency range of 47–1006 MHz to support VHF and UHF broadcast bands and cable TV signals. The unit uses F-type connectors for input and output and is powered from an AC supply with typical consumption of 3 W, making it suitable for installations where stable gain and low power use are required. Its compact housing (170 mm x 100 mm x 65 mm) allows for mounting in cabinets, on walls, or near antenna systems.
The amplifier delivers consistent signal amplification across the full 47–1006 MHz band, improving signal strength and reducing picture loss in weak-reception areas. Low power consumption and AC operation provide compatibility with common mains supplies, while the use of F connectors ensures easy connection with standard coaxial cables. Compact dimensions and a straightforward hardware design simplify installation and integration with existing distribution equipment.
Install the Triax GHV 530 inline between the antenna or incoming coaxial feed and the distribution network or TV receiver. Connect the antenna cable to the input F connector and the output F connector to the downstream coaxial cable. Ensure the amplifier is connected to an AC mains source within the specified input voltage range. After powering the unit, verify signal levels at the receiver and adjust downstream components or splitters as needed to achieve optimal signal quality. Follow standard safety precautions when working with mains-powered devices.
Place the amplifier in a dry, ventilated location away from direct heat sources and moisture. Minimize the length of coaxial runs before and after the amplifier to reduce potential signal loss. Use properly shielded coaxial cables and quality F-type connectors to maintain the integrity of the amplified signal. If signal overload or noise is observed, check for faulty connectors or excessive upstream signal strength and consider adding an attenuator or reconfiguring splitters.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}