Pipe Clamps DN100, Vaillant (set of 5) – for 100 mm ducting and piping

Set of five Vaillant pipe clamps designed for DN100 (100 mm) ducting and piping. These clamps are intended to secure and support straight pipe sections in heating, ventilation and plumbing systems where a nominal diameter of 100 mm is used. Each clamp provides a stable connection point between the pipe and the mounting surface, helping to maintain alignment and reduce strain on joints and supports.

Advantages

The pipe clamps offer a consistent fit for DN100 pipes and are supplied as a matched set of five to simplify installation planning. Their design allows for straightforward attachment to walls, brackets or structural elements, ensuring reliable pipe support. Using dedicated clamps reduces movement and vibration transfer along ducting and piping runs, which contributes to longer service life for connected components.

Suitable for

• Fixing and supporting 100 mm HVAC ducting
• Mounting DN100 water or sewage pipes to walls or supports
• Securing gas or fuel lines where compatible materials are used
• Installation of straight pipe runs in boiler rooms and plant rooms

Key specifications

• Quantity: set of 5 clamps
• Designed for nominal pipe diameter: 100 mm (DN100)
• Intended application: mounting and support of straight pipe sections
• Compatible with typical HVAC, plumbing and gas piping materials of corresponding diameter
• Mounting method: fixed attachment to wall, bracket or structural element

How to use

Select the clamp positions along the straight pipe run at appropriate intervals for the application and expected loads. Position the clamp around the pipe so that the pipe rests evenly in the clamp saddle, then secure the clamp to the mounting surface with suitable fasteners for the substrate. Ensure clamps are aligned so the pipe is supported without introducing bending stresses; adjust spacing if necessary to meet local installation standards and load requirements.

Usage recommendations

Choose corrosion-resistant fasteners and follow applicable national or local codes when installing pipe clamps. Verify material compatibility between the clamp and the pipe medium (water, gas, exhaust) and allow for thermal expansion by spacing clamps according to the pipe material and operating temperature.