Copper 45° Bend VIEGA 95040, Diameter 28 mm, Pack of 10

VIEGA 95040 is a copper 45° pipe bend with a 28 mm diameter, supplied in a pack of 10 pieces. Intended for plumbing and heating installations, the elbow provides a reliable change of direction for copper piping runs and supports both soldered connections and push-in/pluggable joining methods. The product is compatible with potable water and heating circuits and is suitable for use in residential and commercial systems where a compact directional fitting is required.

Advantages

The copper construction offers good thermal conductivity and corrosion resistance in typical domestic and commercial environments. The 45° angle enables smoother directional transitions compared with sharper angles, reducing flow resistance and facilitating routing in confined spaces. Compatibility with both soldered joints and plug-in connections increases installation flexibility and speeds up assembly when combined with appropriate joining techniques.

Suitable for

• Potable water distribution lines in residential and commercial buildings
• Heating circuits and radiator connections
• Piping routing where a 45° change of direction simplifies layout
• Repair and retrofit work on existing copper systems

Key specifications

• Material: copper
• Angle: 45°
• Nominal diameter: 28 mm
• Connection type: suitable for soldered joints and push-in/plug-in connections
• Pack quantity: 10 pieces

How to use

Prepare the pipe ends by deburring and cleaning to ensure proper contact surfaces for soldering or push-in connections. For soldered joints, apply appropriate flux, assemble the fitting onto the pipe, heat to the required temperature and feed solder to achieve a secure capillary joint. For push-in or plug-in systems, follow the specific manufacturer's instructions for insertion depth and any necessary sealing elements. Verify alignment and support the piping to avoid stress on the joint after installation.

Usage recommendations

Use compatible solder and flux for potable water systems and follow local plumbing codes. When using push-in connections, ensure the receiving system and O-rings (if applicable) are clean and undamaged. Support the piping at recommended intervals to prevent movement and thermal expansion stress on fittings.