Hand plane Vorel 25887, steel body, 235 mm length, single piece

Vorel 25887 is a hand plane with a steel body and a 235 mm base length designed for smoothing and leveling wood surfaces. Supplied as a single piece, this compact plane is intended for carpentry, joinery and light woodworking tasks where controlled material removal and accurate edge finishing are required. The grounded base and varnished finish provide a stable contact surface and moderate protection against corrosion for routine workshop and on-site use.

Advantages

The steel body ensures rigidity and consistent flatness while the hardened manganese steel blade maintains a sharp cutting edge for longer periods. Two adjustment screws allow fine control of blade projection for precise planing depth, and a metal knob provides secure blade pressure. Front and rear ABS handles provide ergonomic grip and better control during use, while the moderate size of the plane makes it versatile for both broad surface smoothing and working on edges or tight areas.

Suitable for

• Smoothing and leveling wooden boards and panels
• Trimming edges and removing small amounts of material
• Preparing surfaces before finishing or painting
• Light joinery and carpentry tasks in workshop or on-site
• Working with some wood-based materials and selected plastics

Key specifications

• Body material: steel with varnished surface
• Base length: 235 mm; base width: 50 mm
• Blade material: hardened manganese steel, blade width approximately 44 mm
• Blade thickness: 1.8 mm sheet metal construction
• Blade hardness: approximately 50–55 HRC for wear resistance
• Blade pressure: metal knob with two adjustment screws for fine depth control
• Handles: front and rear handles made of ABS plastic
• Base finish: ground for improved flatness and contact

How to use

Secure the blade in the plane and set initial blade projection using the metal knob and adjustment screws to a minimal setting. Hold the plane with one hand on the rear handle and the other at the front for guidance. Move the plane along the grain with steady, even strokes applying light downward pressure; increase blade projection gradually if additional material removal is required. Periodically check the surface flatness and adjust the blade depth to avoid gouging. After use, clean shavings from the sole and blade, retract the blade slightly for safe storage.

Usage recommendations

Use the plane with sharp, properly set blade for best results; work with the wood grain to reduce tear-out. For hardwoods or dense materials, reduce the cut depth and make several passes rather than a single deep cut. Keep the ground base clean and free of debris to maintain consistent contact with the workpiece. Store in a dry place to preserve the varnished finish and prevent corrosion.