Watercool MO-RA IV Control pass-through cable – Watercool model 26085

The Watercool MO-RA IV Control pass-through cable is designed to provide a dedicated route for control signals through the Watercool MO-RA IV radiator housing. It enables a tidy, protected connection between the radiator and compatible controllers or devices, supporting reliable signal transfer for fan speed control, lighting, or other control functions when integrating the MO-RA IV into a custom cooling system or replacing original cabling.

Advantages

This pass-through cable preserves neat cable management by allowing internal wiring to be routed through the radiator housing rather than across its exterior. The cable is manufactured to match the physical routing and connector requirements of the MO-RA IV, reducing strain on connectors and improving longevity of the connection. Designed specifically for the MO-RA IV, it simplifies system integration and replacement of worn or damaged control wiring while maintaining consistent signal transmission.

Suitable for

• Routing control signals between a MO-RA IV radiator and compatible controllers or control devices
• Replacement of original MO-RA IV control cabling in existing custom cooling setups
• System integration where concealed or protected cable routing through the radiator housing is required

Key specifications

• Type: pass-through control cable designed for radiator housing routing
• Compatibility: intended for use with the MO-RA IV radiator family and compatible controllers
• Function: transmits control signals (e.g., fan speed, lighting or similar control interfaces)
• Construction: jacketed cable optimized for internal routing and connector strain relief
• Purpose: replacement or extension of factory control wiring for neat cable management

How to use

Install the pass-through cable by routing it through the designated opening in the MO-RA IV radiator housing and connect the cable ends to the radiator’s internal control interface and the external controller or device. Ensure connectors are fully seated and that the cable has appropriate slack to avoid tension at connection points. If replacing existing cabling, remove the old cable carefully and match the connector orientation and pin assignments before making the final connection. After installation, verify proper signal transmission by testing the connected control functions such as fan speed or lighting control.

Usage recommendations

Use the cable only with compatible controllers and MO-RA IV radiator models. Avoid sharp bends or excessive pulling during installation, and route the cable to minimize exposure to potential sources of abrasion or heat. Periodically inspect connections for secure seating and any signs of wear; replace the cable if insulation or connectors show damage.